Filter
Top Products
5
INSTALL SHELVES
Product shelves and a bag containing shelf
support clips are packed inside the unit. Refer to
Table 1 to verify quantity of shelves and shelf
supporting clips. Bottom shelf must be placed on
interior floor and should be inserted into the two
retainer clips provided at the rear corners or the
unit floor.
WARNING
Improper shelf clip installation may cause shelf
and/or product to fall which could result in
personal injury or damage to the unit.
WARNING
Do not overload the shelves. The unit is designed
to use all the shelves provided, installed in
equally spaced configuration. Failure to install
shelves correctly could result in personal injury or
damage to the unit. If fewer shelves or a different
installation configuration is desired, contact the
manufacturer to ensure that shelf overloading will
no occur.
TO INSTALL SHELVES
1. Determine proper location for shelf clips.
Refer to the numbers on the pilaster to
ensure that all clips are properly located.
2. Insert top tab of the shelf clip into the
desired hole of the pilaster. The retaining
tab should be facing upward as shown in
Figure 4.
3. Rotate the clip downward and insert the
bottom tab into the appropriate hole on the
pilaster. If necessary, squeeze the clip
slightly during installation.
4. Install all remaining clips as described
above.
5. Install shelves onto clips so that the product
retention bar is facing upward. Be careful
not to dislodge clips during shelf installation.
6. Shelves must be placed so that the retaining
tab on the shelf captures the shelf as shown
in Figure 5.
7. Before loading the shelf, ensure that the
shelf is resting on each of 4 clips and that
the clip are installed as shown in Figures 4
and 5.
FIGURE 4 – SHELF CLIP INSTALLATION
FIGURE 5 – PROPER INSTALLATION OF
SHELF ON CLIP
CONDENSATE DISPOSAL
The evaporator drain pan is located in the base of
the product. Airflow in compartment hastens
condensate evaporation so that external drain
plumbing is not required.