Filter
Top Products
Installing the wine cooler
This appliance is intended to be built in to a kitchen cabinet.
This appliance should be installed in a well ventilated, dry room.
This appliance must not be installed:
1. In direct sunlight
2. Adjacent to a heat source (oven or radiator)
3. Below a hob unit
Place your wine cooler in a location which is strong enough to support its weight when fully loaded. To level the wine cooler,
adjust the front levelling legs at the bottom of the wine cooler.
Ensure that there is an adequate flow of air at the rear of the cabinet, as shown in the diagram.
Please note that a plinth vent of at least 200 cm² is recommended to allow for sufficient ventilation. If a ventilation intake is
provided elsewhere, the plinth vent may not be necessary
IMPORTANT: Failure to follow the instructions regarding installation and ventilation may invalidate the
warranty supplied with your appliance.
To ensure the proper functioning of the appliance, air vents should never be blocked or covered.
To install the handle
IMPORTANT: Do not overtighten the screws, and do not use power tools to install the handle.
1. Carefully remove the door seal on the side you wish to install the handle.
2. Insert the screw from the inside of the door frame and screw it in to the handle, using the screws, lock washers and flat
washers provided.
3. Replace the door seal.
FWV900
FWV450
537
540
459
445
592
18
447 - 452
550 - 560
560 - 568
min. 200cm
2
min. 200cm²
537
540
884
871
592
18
873 - 878
550 - 560
560 - 568
min. 200cm
2
min. 200cm
2