Filter
Top Products
Reversing the door
It is possible to reverse the door on this appliance, if required.
To do so, follow the steps below:
1. With the door closed, remove the upper hinge pin cover, and then the upper and lower hinge pins. Support the door to
prevent it falling.
2. Remove the door carefully and place it on a padded surface to avoid the risk of damage.
3. Unscrew the four upper hinge plate screws on the right hand side and the blanking screws on the upper left hand side.
Remove the right upper hinge plate. Fit the left upper hinge plate, supplied with the instructions, using the four hinge plate
screws, and then fit the blanking screws on the right.
4. Unscrew the four lower hinge plate screws on the right hand side and the blanking screws on the lower left hand side.
Remove the right lower hinge plate and rotate the hinge plate 180˚. Refit the lower hinge plate on the lower left hand side
using the four hinge plate screws, and then fit the blanking screws on the right.
5. Rotate the door 180˚ and then relocate it on the upper and lower hinge plates. Refit both upper and lower hinge pins.
6. To level the door, adjust the upper and lower hinge plate screws and then tighten securely.
Please note: Keep the spare upper hinge plate to be able to reverse the door back again.
Table of parts
1. Upper screws
2. Hinge pin cover
3. Upper hinge pin
4. Right upper hinge plate
5. Door
6. Left upper hinge plate
7. Lower hinge plate
8. Lower hinge pin
9. Lower screws
1
2