Filter
Top Products
The Icemaker
To make ice
The icemaker will make ice automatically once it is switched on and will continue to make ice until the ice compartment
is full. Whenever ice is removed, the icemaker will make more ice until the compartment is full again.
To dispense water
The amount of water dispensed from the water nozzle is controlled by three different buttons.
– water glass
– water jug
– manual setting – this button dispenses water as long as the button is pressed.
The water nozzle is height adjustable for ease of use. To adjust the height, hold the black outer section of the water
nozzle and raise or lower it to the height required. The nozzle will automatically remain at the height set.
To change the preset buttons
It is possible to adjust the amount of water dispensed by the preset buttons ( & ). To do so, place a glass or jug
under the water nozzle and press button 5 until the required amount has been dispensed. Then confirm the setting by
pressing buttons & for the water glass button or buttons & for the water jug button.
Please note:
To stop water dispensing once a preset button has been pressed, simply press the button again.
To dispense ice
When the ice drawer is full, the display shows ICE FULL WATER READY.
Open the drawer fully and use the scoop provided to remove the ice as required.
Please note:
To ensure the ice is fresh, we recommend you empty the ice drawer every 6-8 hours.
If the ice drawer is not emptied for a long period of time, the appliance will go on standby for approximately ten
minutes, and the display shows ICE OFF WATER READY. After the standby period has ended, the appliance will begin
to make ice again. If you do not want to wait for the standby period to finish, press the ON button.