CDA RC9301 Cooktop User Manual


 
40
Electrical installation
For your safety please read the following information:
This appliance must be installed by a qualified technician according with the
current local regulations and in compliance with the manufacturer instructions.
This appliance is supplied with a moulded 13 amp three pin mains plug with a 3
amp fuse fitted. Should the fuse require replacement, it must be replaced with a fuse
rated at 3 amp and approved by ASTA or BSI to BS 1362.
The plug contains a removable fuse cover that must be refitted when the fuse is
replaced. In the event of the fuse cover being lost or damaged, the plug must not
be used until a replacement cover has been obtained.
Replacement fuse covers can be purchased from your nearest electrical dealer and
must be the sarne colour as the original.
IF THE MOULDED MAINS PLUG IS UNSUITABLE FOR THE SOCKET OUTLET IN YOUR
HOME OR IS REMOVED FOR ANY OTHER REASON, THEN THE FUSE SHOULD BE
REMOVED AND THE CUT OFF PLUG DISPOSED OF SAFELY TO PREVENT THE HAZARD
OF ELECTRIC SHOCK.
THERE IS A DANGER OF ELECTRICAL SHOCK IF THE CUT OFF PLUG IS INSERTED INTO
ANY 13 AMP SOCKET OUTLET.
If a replacement plug is to be fitted, please observe the wiring code shown below.
A properly earthed three pin plug (fused
at 3 amps, to BS 1362 ASTA approved)
must be used.
As the colours of the wires in the mains
lead of this appliance may not
correspond with the coloured markings
identifying the terminals in your plug,
proceed as follows.
The wire which is coloured GREEN &
YELLOW must be connected to the
terminal in the plug which is marked
with letter "E" or by the Earth symbol or
coloured GREEN & YELLOW.
The wire which is coloured BLUE must
be connected to the terminal which is
marked with the letter "N" or coloured
BLACK.
The wire which is coloured BROWN
must be connected to the terminal
which is marked with the letter "L" or
coloured RED.
Warning! This appliance must be earthed
Green & Yellow
Earth
3 amp fuse
Blue Neutral
Brown Live
Fig. 47