Filter
Top Products
41
Electrical installation
Connecting feeder cable
To connect the feeder cable to the cook-
er it is necessary to:
– Remove the screw that hold shield “A”
behind the cooker (fig. 41).
– Insert the feeder cable of the suitable
section (as described in the next chap-
ter) into the cable clamp “D”.
– Connect the phase and earth cables to
the terminal block “B” according to the
diagram in figure 42.
– Pull the feeder cable and block it with
cable clamp “D”.
– Re-mount shield “A”.
The appliance must be connected to the electrical network verifying above all that the
voltage corresponds to the value indicated on the specifications plate and that the
cables section of the electrical plant can bear the load which is also indicated on the
plate.
The cooker can be connected directly to the mains placing an omnipolar switch with
minimum opening between the contacts of 3 mm between the appliance and the
mains.
The power supply cable must not touch the hot parts and must be positioned so that it
does not exceed 75°C at any point.
Once the cooker has been installed, the switch must always be accessible.
Before effecting any intervention on the electrical parts the appliance must
be disconnected from the network.
Warning!
Electricity can be extremely dangerous.
This appliance must be earthed.
230 V
PEN
L
1
(L2)
Fig. 42
Feeder cable section
TYPE HO5RR-F
230 V 3 x 1,5 mm
2
D
B
A
PE
Fig. 41