Filter
Top Products
27
Replacing the oven
light
Before any maintenance is started
involving electrical parts of the appli-
ance, it must be disconnected from the
power supply.
– Let the oven cavity and the heating
elements cool down;
– Unscrew the protective cover C (fig.
19);
– Unscrew and replace the bulb B with
a new one suitable for high tempera-
tures (300°C) having the following
specifications: 230-240V 50 Hz, 15W,
E14 and same power (check watt
power as stamped in the bulb itself)
of the replaced bulb.
– Refit the protective cover.
NOTE: Oven bulb replacement is not
covered by your guarantee.
B
C
Fig. 19
C
B
Inside of oven
The oven should always be cleaned
after use when it has cooled down.
The cavity should be cleaned using a
mild detergent solution and warm
water. Suitable proprietary chemical
cleaners may be used after first consult-
ing with the manufacturers recommen-
dations and testing a small sample of
the oven cavity. Abrasive cleaning
agents or scouring pads/cloths should
not be used on the cavity surface.
NOTE: The manufacturers of this appli-
ance will accept no responsibility for
damage caused by chemical or abra-
sive cleaning.
Let the oven cool down and pay
special attention no to touch the
hot heating elements inside the
oven cavity.