CDA RV 701 SS Range User Manual


 
39
Electrical Installation
WARNING! Electricity can be extremely dangerous.
This appliance must be earthed.
The appliance must be connected to the electrical network verifying above all that the voltage corresponds
to the value indicated on the specifications plate and that the cables section of the electrical plant can bear
the load which is also indicated on the plate.
It is recommended that the appliance is connected directly to the mains by fixed wiring, placing a double
pole switch with minimum opening between the contacts of 3 mm.
The power supply cable must not touch the hot parts and must be positioned so that it does not exceed
75°C at any point.
Once the cooker has been installed, the switch must always be accessible.
Before effecting any intervention on the electrical parts the appliance must be disconnected
from the network.
Electrical Feeder Cable Connection
To connect the feeder cable to the cooker it is necessary to:
– Remove the 2 screws that hold shield A behind the cooker.
– Open completely the cable clamp D.
– Insert the feeder cable into the cable save P. The supply cable
must be of a suitable size for the current requirements of the
appliance; see the section “Feeder cable section”.
– Connect the phase and earth cables to terminal B according to
figures 45 and 46.
– Pull the feeder cable and block it with the cable clamp D.
– Re-mount shield A.
Note: The earth conductor must be left
about 3 cm longer than the others.
Feeder Cable Section
Type H05RRF
230 V~ 3 x 2.5 mm
2
(*)
(*): Connection with wall box connection
230 V
PEN
L
1
(L
2
)
PE Earth
N Neutral
L Live
P
D
B
A
Fig. 45
Fig. 46