CDA SV500 Convection Oven User Manual


 
Troubleshooting
If the oven is not functioning correctly, check the advice below prior to calling CDA Customer Care.
The oven display will show error codes if there is a fault with the appliance. These are detailed below. Before calling CDA
Customer Care, take note of the error code as this will help when attempting to resolve the problem.
Problem Possible Cause Advice
The oven does not heat up There is no power supply to the oven
Check the oven is switched on at the
cooker point and the fuse/circuit
breaker has not activated.
The padlock on the display is flashing Door lock system fault Call CDA Customer Care
The oven light is not working Light fault Replace the bulb
The pyrolysis programmes do not start The door is not properly closed Close the door completely
Door lock system fault Call CDA Customer Care
The oven starts beeping during cooking The oven is at the required temperature
The oven starts beeping at the end of
the cooking programme
The programme has finished
Error Code Fault
F01 Temperature sensor error
F02 Overheated oven . First ensure there is adequate ventilation to the oven as described on page 16.
F03 Pyrolysis failure (door locked)
F04 Door interlock
F05 Other cooking fault
F10 Information only – power cut during cooking
AUTO
Auto stop. The oven is equipped with an auto stop function to automatically switch off the oven if it is in
continuous use for more than 23 hours and 30 minutes.
15