Filter
Top Products
7
Illustration No. 7
SLINGER DISC
INSERT
CHAMBER
MIXING
PRODUCT SHUTE
MIXING CHAMBER MOUNT
MIXER BLADE
EXTENSION
CHAMBER
MIXING
CHAMBER
MIXING
DEFLECTOR
STEAM
HOPPER ASS'Y
PRODUCT
SWITCH
HEATER
DRIP TRAY BRACKET
DRIP TRAY
GRILL
SWITCH
RINSE
TOP COVER
MIXING CHAMBER PLATE
MIXING CHAMBER SPACER
DRIP TRAY BRACKET
SEAL (GASKET)
HEATER
SWITCH
SWITCH
RINSE
HOPPER ASS'Y
PRODUCT GUIDE
EXTENDER
CHAMBER
DEFLECTOR
CHAMBER
WING NUT
CLEANING INSTRUCTIONS
GRILL
DRIP TRAY
MIXING
STEAM
MIXING
ICAP MINI B LD (with Lit Door)
MINI WHIPPER B (without Lit Door)
TOP COVER
CLEANING INSTRUCTIONS
NB04A
WHIPPER B (without Lit Door)
ICAP1 B LD (with Lit Door)
CLEANING INSTRUCTIONS
CLEANING INSTRUCTIONS
NA62C
OPTIONAL
DAILY:
1. Wipe exterior of dispenser with a soft damp cloth.
Deflector setup by pulling forward.
2. Disengage Product Hopper by lifting straight up,
while retaining in the upright position.
3. Remove Mixing Chamber by turning Counterclockwise
and pulling forward.
A. Remove Mixing Chamber Insert by pulling up.
B. Remove Mixing Chamber Extension by pulling down.
4. Remove Mixer Blade by pulling forward.
5. Wash Grill, Mixer Blade, Insert, Extension, and Mixing
Chamber with a mild detergent.
6. Wipe upper compartment with a damp cloth.
7. Replace all parts including Hopper.
8. Dry thoroughly before reloading with product.
DAILY:
1. Wipe exterior of dispenser with a soft damp cloth.
Deflector setup by pulling forward.
2. Wash Drip Tray with hot water.
3. Flush Mixing Chamber by depressing Rinse Button
approximately 10 seconds.
WEEKLY:
NOTE: IN VERY HIGH VOLUME LOCATIONS, THIS
PROCEDURE SHOULD BE DONE TWICE A WEEK.
1. Open Top Cover, Door Assembly, and remove Steam
Deflector setup by pulling forward.
2. Disengage Hopper by lifting straight up,
while retaining in the upright position.
3. Remove Mixing Chamber by unscrewing wing nuts.
4. Wash all components after removing.
5. Wipe upper compartment with a damp cloth.
6. Replace all parts including Hopper.
7. Dry thoroughly before reloading with product.