1WARNING: Disconnect power before
attempting any maintenance or cleaning
to reduce the risk of fire, electrical shock
or personal injury.
Maintenance of Motors
The motors used on the fan and the flame generator
assembly are prelubricated for extended bearing life
and require no further lubrication. However, periodic
cleaning/vacuuming of the fan/heater unit is recom-
mended.
WARNING: Make sure the power is turned
off before proceeding.
Service Instructions
Replacing Light Bulbs
This stove uses two clear 120 Volt, 60 Watt, E-12
socket base light bulbs (small base, chandelier candle-
type). The 60 Watt bulbs are located under the log
set/ember bed. For convenience, if one of the bulbs
burns out, it may be a good idea to replace both of the
light bulbs.
1. Turn off power to the unit by unplugging the power
cord.
2. Let stove cool if it has been operating.
3. Remove rear access panel from back of pedestal to
expose light bulbs.
6
S190006
Fan Assembly
ST818
Fig. 2 Secure fan assembly to base of pedestal.
Fig. 3 Attach brass handle to front of unit.
CAUTION: Be careful not to touch or bend the flame
generator.
4. Examine the bulbs to determine which bulb needs
to be replaced.
5. Unscrew defective bulb(s).
6. Install new 60 Watt light bulb(s).
7. Replace rear access panel. Plug power cord into
wall outlet.
WARNING: Do not exceed 60 watts per
bulb. Use of higher rated bulbs may result
in a fire, causing property damage or per-
sonal injury.