Filter
Top Products
2
1/4-20x1/2” screw
1
Attach side panels to bottom shelf using
three 1/4-20x1/2” screws, 7mm lock
washers, and 7mm flat washers per panel.
IMPORTANT: Panel with large hole must
be on left side of bottom shelf.
7mm lock washer
7mm flat washer
Left side panel
(with large hole)
Make sure side panels
are pushed as far to the
rear of bottom shelf as
possible before fully
tightening screws.
Right side panel
Magnets
ASSEMBLY
13
Qty.6
Qty.6
7mm lock washer
7mm flat washer
Locking caster
Bottom shelf
Non-lock caster
Rear
Front
Bent U pin
A
Place bottom shelf upside down. Insert Bent U Pin into the caster mounting plate to lock it in place, shown A.
Bent U pin
Qty.1
Spin the caster clockwise into the threads on the bottom shelf until secure. Remove the Bent U Pin and
repeat for remaining casters. Make sure the two locking casters are secured at the rear and the non-locking
casters are secured at the front. After all 4 casters are secure remove the Bent U Pin and save for future
maintenance.
1/4-20x1/2” screw
Qty.6