Filter
Top Products
CAL 9900 Controls Drawing
MIXER KETTLE OPERATION
USING CAL 9900
Note: Temperature probe on mixer bridge must
be covered with a minimum of three inches of
product to function correctly.
5. Push (
*
) button on CAL 9900 to read set point
temperature. (This is the desired product
temperature).
6. To change set point temperature push and
hold (
*
) button while pushing ( ) or ( )
button. New set point is determined when
(
*
) button is released.
7. Add product to kettle.
8. Turn ACTIVE/BYPASS switch to
“ACTIVE”. If the set point
temperature is higher than the
product temperature, the kettle will start heating.
Note: For twin kettles, the CAL 9900 will control
the kettle the mixer is in.
Changing Functions & Options
The controller has been preset at the factory and should
operate satisfactory. If you wish to fine tune the unit for
your specific application consult the CAL 990O
Installation and Operation Manual. Following is a
simplified procedure for changing parameters.
BYPASS ACTIVE
BYPASS ACTIVE
HEAT AUTO COOL
OFF
OFF ON
1. Open STEAM VALVE completely
2. Turn mixer MAIN POWER switch to
"ON" (CAL 9900 lights up and
displays present temperatures).
3. Turn HEAT/COOL switch to
“OFF/AUTO".
4. Turn ACTIVE/BYPASS switch to
"BYPASS". The unit should not be
heating or cooling at this point.
CAL 9900 ˚C
*
p
Process
Temperature
or Set Point
SP1
SP2
Hi
Sp
Lo
*
*
*
Decrease
Increase
View Set Point
Error
CAL 9900 ˚C
p
*
CAL 9900 ˚C
p
*
CAL 9900 ˚C
p
*
CAL 9900 ˚C
p
*
CAL 9900 ˚C
p
*
CAL 9900 ˚C
p
*
BYPASS ACTIVE
OFF ON
Cleveland
Range
Factory
Settings
OPERATING FUNCTION
MODE NUMBER
0 0
0 1
5 2
0 3
4 steam
4
5 electric
0 5
5 6
0 7
0 8
1 9
0 10
0 11
0 12
0 13
0 14
0 15
9 16
0
17
0 18
1 19
2 T.A.P
20
0
0 21
0 = °C
22
1 = °F
6 23
-- -- 24
0 25
-- -- 26
1. Mixer MAIN POWER switch in the "ON"
position.
2. ACTIVE/BYPASS switch in "BYPASS" position.
3. Press button labeled (p). The display should show a
number with a decimal place in it.
Left of the decimal
place is the
OPERATING MODE
setting (this number
should be flashing).
To the right is the
FUNCTION NUMBER
.
4. To change the
OPERATING MODE
setting push the
( ) or ( )
buttons.
5. To move to the
FUNCTION NUMBER
(right of the
decimal) push
(
*
) button.
6. That number
should now be
flashing. To move
to another
FUNCTION
NUMBER
push the
()or ()
buttons.
7.
Push (
*
) button to
move to the left of the
decimal. To change
the
OPERATING MODE
setting push the
() or ()
buttons.
8.
When your changes
are complete push
the button labeled
(p) again to return
to the
Process
Temperature
.