Filter
Top Products
MRC 7000 ENABLE MODE
PROCEDURE (1&2 PEN)
For Cook Chill Direct Steam Mixer Kettles
Reference page #36 in the MRC 7000 Installation,
Wiring, Operation Manual, Form 2877, Edition 6,
May 1994 update.
To prevent tampering, your programmer comes
from the factory with the programming modes
turned "oFF ".
If adjustment is required then the modes must be
turned "ON " before they are accessible. We
recommend that when the adjustments have been
completed you turn off the programming modes again
.
To turn on the mode required perform the
following steps:
CAL 9900 Controls Drawing
1. Turn MAIN POWER SWITCH to "ON ".
2.
Press the scroll key " " until "CtrL" is displayed.
3. Press and hold the " " and " " keys at the
same time. All the display lamps will light.
4. After 10 seconds the display lights will go out
and "EnAb" will be displayed. Release the
" " and " " keys. "EtSt " will appear.
5. Repeatedly press the " " key until the
desired mode is displayed.
6. Press the
scroll key " "
once to display the
mode’s setting ("ON " or "oFF ").
7. Press the " " key to turn the desired mode
"ON ".
8. To turn desired mode "oFF " follow steps 1-5
and then press " " key.
MRC 7000 Enable Mode Flow Chart
Press and hold both keys until "
EnAb
" appears
(about 10 seconds).
When you release the keys "
EtSt
" will appear.
Push to turn "
on
"
Push to turn "
oFF
"
EnAb
EtSt oFF
ECAL
oFF
EPro
oFF
Etun
oFF
ESbY
oFF
ESPS
oFF
ESPC
on
Test
Mode
Calibration
Mode
Program
Mode
Tune
Mode
Manual
(Stby)Mode
Setpoint
Change
Setpoint Select
Mode (optional)
Factory
Setting
Factory
Setting
Factory
Setting
Factory
Setting
Factory
Setting
Factory
Setting
Factory
Setting
SP
MAN OUT1 OUT2 ALRM
Pen1 key -
AUTO/MAN
AUTO
MAN
SCROLL Key
UP Key
DOWN Key
Pen 2 key -
AUTO/MAN
AUTO
MAN
Note: Pressing the up key while
any of the modes are displayed will
exit you from the "EnAb" program.