Filter
Top Products
Getting Started
5. Connect the blue wire you removed from the Main Contactor coil terminal to the #250
Piggyback Connector and connect the blue wire from terminal 10 of the Timer Relay
Socket to the same #250 Piggyback Connector on the coil terminal. See Figure 1 and
Figure 2 on the previous page.
6. Remove the red wire from the Main Contactor coil terminal (see Figure 2 on the previous
page) and put the other #250 Piggyback Connectors (P/N 52000.00) on the coil terminal.
7. Connect the red wire you removed from the Main Contactor coil terminal to the #250
Piggyback Connector and connect the red wire from terminal 11 of the Timer Relay
Socket to the same #250 Piggyback Connector on the coil terminal. See Figure 1 and
Figure 2 on the previous page.
8. Pop out the rocker switch hole plug from the Auto Fill switch position in the front panel.
There are two violet wires attached to it. Pull the two wires off of the hole plug and
connect them—either wire to either terminal—to the two terminals on the Rocker Switch
(P/N 00421.89) from the kit and insert the Rocker Switch into the hole. Position the
switch so that it rocks to the right when actuating.
9. The other ends of the two violet wires coming from the Rocker Switch are bundled into
the wire harness. Free up the ends for easy access. Connect the two violet wires from
terminals 2 and 6 of the Timer Relay Socket to the ends of the two violet wires coming
from the Rocker Switch. See Figure 1 on the previous page.
10. Using one of the two 1/2" Straight Connectors (P/N 00401.20) that came with the kit,
mount one end of the 1/2", 2 feet Conduit (P/N 00400.10) to a 7/8” hole in the back of the
control cabinet.
11. Secure the remaining 1/2" Straight Connector to the other end of the 1/2" Conduit and
route the blue/yel wire from terminal 10 of the Timer Relay Socket and the orange wire
from terminal 9 of the Timer Relay Socket through the 1/2" Conduit to the Solenoid Valve.
12. Using the two Wire Nuts (P/N 00661.00) connect the blue/yel wire and the orange wire to
the two wire leads coming from the solenoid—either wire to either wire. Connect the 1/2"
Conduit to the Solenoid Valve with the 1/2" Straight Connector.
13. Plug the Timer Relay (P/N 13418.85) into the Timer Relay Socket and check that it is set
up as follows:
0
6
9 12
15
18
OUT POWER
D
MODE
1
RANGE
0
S
GT3A
idec
Timer Dial
Range
Scale
a. Mode selected is “D”
b. Scale displayed is “0 – 18”
c. Range selected is “10S”
d. Timer dial is set near 9 ½
Mode
14. Turn on the machine and test your new Auto Fill feature.
When Auto Fill is activated (and the rinse pressure is set to 20 PSI), the machine should fill until it
begins to overflow into the scrap tray, at which point it should stop filling. If needed, adjust the
time setting on the Timer Relay to accomplish this.
Users note: If at any time less than a full Auto Fill cycle is desired the Auto-Fill can be interrupted
(stopped) by turning off the power to the machine. The machine will resume normal operation
upon restoring power without continuing the Auto Fill cycle.
MODEL CMA-66 Installation & Operation Manual Rev. 1.06 01/11/05 Page
13