Creda Double Oven Range User Manual


 
36
Before calling a Service Engineer, please check through the following lists.
THERE MAY BE NOTHING WRONG.
SOMETHING WRONG?
Problem
Nothing works.
Display shows 0.00 AUTO.
Main & Top Ovens do not work, but
the Grill works.
Top Ovens and Grill do not work,
but the Main Oven works.
Grill does not work.
Grill keeps turning on and off.
Can not set an “Auto Cook” pro-
gramme
Draught from beneath control
panel.
Control panel illumination remains
on, or comes on again, after the
controls have been turned off.
Timer buzzer/bleeper operates
continually
Check
(a) Check
If you find :-
Display is blank.
Then it is likely that there is no electricity supply to your oven.
Check: (i) That the main cooker wall switch is turned on.
(ii) Check other appliances to see if you have a power
cut.
(iii) Check the main circuit breaker for the property.
The power supply to your oven has possibly been interrupted, but has
now come back on again. Reset the timer to the correct time of day and
"Manual" operation using instructions given in the timer
section of the book.
Check the following to ensure that the timer is in Manual Mode:
Check that the Auto Symbol is not lit up and is not flashing.
See timer section for instructions on how to return timer to
"Manual".
Operating the cooker under the following conditions may cause a
safety device to operate.
(a) Grilling with the door closed - always grill with the door open
to the correct position - see grilling.
(b) Grilling for an excessively long period at maximum setting -
see grilling guide.
(c) Grilling with inadequate ventilation in the cabinet - see
installation instructions.
Check that you have selected :- "Grill" function on the "Top/Oven Grill
Select" knob (B) and a Grill setting on the "Grill" knob (A) - see
grilling page.
When the "Grill" control (A) is operating at less than "6", the grill will cycle
on and off, this is normal and is not a fault.
Remember: "Cook Period" is the actual length of time for which, the
timer will switch the oven(s) on as part of an "Auto Cooking"
programme.
A gentle flow of air will be blown from beneath the control panel when the
appliance is used. If the appliance is still warm, this
cooling fan may run on, or restart itself after all of the controls have
been turned off.
The fan will stop once the appliance has been cooled. This is normal
and not a fault.
The control panel illumination is on the same circuit as the cooling fan (see
above). If the cooling fan runs on, or restarts due to the appliance still being
warm, then the display will remain/become illuminated to indicate that the
appliance is still warm. The fan will stop and the illumination will go off,
once the appliance has been cooled.
This is normal and not a fault.
Buzzer/Bleeper should stop automatically after 2 minutes. If not,
press minute minder button to silence.
If you have been through the above list and there is still a problem; You should identify your Service
Agent using the list on the back page and contact your Local Service Office.