Filter
Top Products
Installation
SITING
The cooker is designed to fit between kitchen cabinets spaced 500mm apart
minimum. The space either side need only be sufficient to allow withdrawal of the
cooker for servicing. It can be used with cabinets one side or both as well as in an angled
corner setting. It can also be used free-standing.
Adjacent side walls which project above hob level, should be protected by heat
resistant material, but in any case should not be nearer to the cooker than 150mm.
Any overhanging surface should not be nearer than 500mm.
Excess steam from the oven is expelled at the rear of the cooker, therefore the wall
behind the cooker needs to be protected against grease and moisture.
This is a type X appliance regarding protection against overheating of surrounding
surfaces.
MOVING THE COOKER
Before moving your cooker ensure that it is cool and note that it is heavy.
Movement of your cooker is most easily achieved by lifting the front as follows:
Open the oven door sufficiently to allow a comfortable grip on the underside front
edge of the oven roof.
21
(6")
150mm
MIN.
(6")
150mm
MIN.
500mm
(20")
500mm (MIN)
APPLIANCE
Note: Take care when moving the cooker as it is heavy. Take care to ensure that any floor
covering is not damaged.