Filter
Top Products
9
desired time can be set by pressing the Hour
and Minute buttons to scroll forward through
the digits. Pressing and holding either button
will allow you to scroll continuously, slowly at
first, and then to accelerate to the rate of about
three digits per second. As the desired time set-
ting approaches, release the button and press
repeatedly to advance one digit at a time. The
coffeemaker will start to brew at the pro-
grammed time. The Program mode cannot be
entered if the coffeemaker is in its brew cycle.
Exiting Set Program Time Mode
Set Program Time may be exited in any of three
ways:
1. Press the Program Set button again. This
will cause the coffeemaker to revert to its
previous state.
2. Press any other button (except Hour or
Minute). Set Program Time mode will be
exited and the function of the button
pressed will be executed.
3. Do nothing. If neither the Hour nor Minute
button is pressed for a period of five sec-
onds, the Set Program Time mode will be
exited and the programmed setting will be
in effect.
Setting the Automatic Shutoff Time
The Automatic Shutoff Time can be pro-
grammed anywhere from immediate shutoff
after completion of the brew cycle up to four
hours.
To check the current setting, press and hold the
On/Off button (about 2 seconds) until the red
light and LCD display begin to flash. This signals
that you have entered the Set Automatic Shutoff
mode. The desired time can be set by pressing
the Hour and Minute buttons to scroll forward
through the digits until the desired time appears.
Pressing and holding either button will allow you
to scroll continuously, slowly at first, and then to
accelerate to the rate of about three digits per
second. As the desired time setting approaches,
release the button and press repeatedly to
advance one digit at a time.
The Automatic Shutoff Time may be pro-
grammed either before or during coffee brewing.
You may also re-program the shutoff time when
brewing has been completed. If you do so, the
unit will automatically account for any time that
has already elapsed after brewing. For example,
if you set the shutoff time for 40 minutes and 25
minutes have already elapsed, the unit will shut
off automatically after 15 minutes (40 minutes
minus the 25 elapsed equals 15 minutes).
INSERTING THE WATER
FILTER
a. Remove the filter from polybag and soak in
cold tap water for 15 minutes.
b. Remove the water filter holder from the
coffeemaker by lifting it out of the reservoir
area with your thumb and forefinger.
c. Grasp the stem in one hand. Using the
thumb of the other hand, gently press
down and pull toward you. Compartment
will flip open.
d. Place the filter in the holder and close
the water filter holder; you will hear a snap
indicating filter is in place.
NOTE: Caution must be used when inserting the
charcoal filter. Improper placement in the holder
can cause tearing of the filter skin.
e. Hold the filter under cold running tap water
for 10 seconds to flush. You should place
the hole openings in the side of the unit
directly under the water stream.
f. Allow the filter to drain completely.
g. Replace the water filter holder in the reser-
voir area of the coffeemaker, pushing it all
the way down to the base of the unit, along
the reservoir wall.
NOTE: We recommend changing the water filter
every 60 days or 60 uses or more often if you
have hard water.
Replacement water filters can be purchased in
stores or by calling customer service or through
the Cuisinart website.