Filter
Top Products
9
with the two slots of the left piece. Gently slide the tabs into the slots
until both pieces are resting flat on the countertop.
To store the hand blender, detach the shaft and place the bottom
part (blade guard) into one of the reservoirs. Place the motor body
(right side up) into the other reservoir. You should be able to read the
Cuisinart
®
logo when the motor body is in the stand.
The charger handle can be attached to the motor body when you store
the unit. This is especially helpful when you want the hand blender
close at hand during a heavy use period. Probably you will want to
plug the charger handle into the electrical socket to keep the battery
charged during other times. The counter storage unit can also be
placed in a cupboard or on a shelf.
Wall Mount Option
Separate the two plastic storage stand pieces. You will need only one
for wall mount. (See diagram below.)
When selecting a mounting location, be sure to leave enough room
above the storage stand for your hand to remove the Cuisinart
®
Cordless Rechargeable Hand Blender. Also be sure to leave enough
room below the stand to allow the appliance to hang freely.
You will need to drill two holes 2-2/3" apart from each other, measured
from the center of each hole. To assist in proper location of holes for
the mounting screws, remove the wall mount template from this
instruction book. Place the template over the back of the wall unit,
aligning the outline of the template with the wall bracket. When you
have done this, place the template and wall bracket against the wall in
the desired location. Remove the wall bracket, leaving the template in
place. Mark the wall with a pencil in the locations indicated for screw
holes by the template. Remove the template.
With a drill, make a 3/16" starter hole for each screw. Place the plastic
anchor in each hole. Push completely into the hole with fingers, or
tap in gently with a hammer. Screw a mounting screw into each hole,
leaving 1/8" to 1/4" of the head and screw exposed.
Position the two mounting holes of the wall bracket over the screw
heads, and slide wall bracket down the wall until the bracket is resting
against the screw head, and will not slide any further. If the wall bracket
feels too loose against the wall, remove bracket, put screws further into
wall, and replace bracket.
Place the assembled hand blender into the wall bracket. The unit will
hang from the bracket, held in place by the motor body width.
The charger handle can be attached to the motor body when you store
the unit. This is especially helpful when you want the hand blender
close at hand during a heavy use period. At other times, you probably
will want to keep the charger handle plugged into the electrical
socket to assure the battery is always 100% charged.
CSB-44N IB-4130 8/4/03 7:10 PM Page 9