Filter
Top Products
7
PROGRAMMING YOUR
COFFEEMAKER
TO BREW COFFEE
1. Turn the function knob to “Brew.”
2. Press the On/Off button and release.
The red On indicator light will illuminate
and brew cycle will begin.
TO TURN THE COFFEEMAKER OFF
Press the On/Off button and release.
Note: This coffeemaker shuts off automatically
after brewing is complete.
PROGRAMMING YOUR COFFEEMAKER
FOR DELAYED BREW TIME
To set the time:
1. Turn the function knob to “Clock.”
a. Set Hour: Press and hold the Hour
button to scroll through numbers quickly.
When number displayed approaches the
desired setting, press and release (pulse)
the button to advance one digit at a
time. After setting the correct hour, the
default will be the last time set unless
power is shut off.
NOTE: When the number count passes 12,
the PM light will be displayed on the LCD.
b. Set Minutes: Press and hold the Minute
button to scroll through numbers quickly.
When number displayed approaches the
desired setting, press and release (pulse)
the button to advance one digit at a
time. After setting the correct minute, the
default will be the last time set unless
power is shut off. To finish setting time,
turn the Function Knob to any other
setting or simply wait until the numbers
stop blinking.
To program the Auto On (brew start time)
1. Turn the function knob to “Prog.”
2. Set the time you want coffee to begin
brewing by using the minute and hour
push-buttons. Follow the same instructions
you used to set the time of day, in the To
set the time section above.
3. Turn the function knob to “Auto On.” LCD
will display the current time.
4. Press the On/Off button and release. The
green indicator light will come on to remind
you that the programming function is in
use. At the programmed time, the red
indicator will come on as well, indicating
that the brew cycle is starting. Both lights
will go off when keep warm cycle ends.
NOTE: To reactivate the auto-on feature to start
brew cycle at the same time another day, simply
press the On/Off button and release. The green
Auto-On light will illuminate.
1 - 4 Cup Setting
The 1- 4 cup setting button is used when you
make small amounts of coffee. The 1-4 cup
setting basically double heats the water, making
your smaller amount piping hot.
To use: When making a smaller amount, press
the 1-4 button on the control panel after turning
on the unit.
Power Loss Back-up
One-minute protection in case a breaker trips,
the unit is unplugged, or the power fails. It holds
all programmed information, including time of
day, auto on time and auto off time.
MAKING COFFEE
Before you make the first pot of coffee in your
new Cuisinart
®
coffeemaker, we recommend
operating the coffeemaker once using only
water and a paper filter. This will remove any
dust or residues that remain in the system from
the manufacturing process.
1. Insert the Water Filter
a. Remove the filter from polybag and soak
in cold tap water for 15 minutes.
b. Remove the water filter holder from the
coffeemaker by lifting it out of the
reservoir area with your thumb and
forefinger.
c. Hold the water filter holder lengthwise
and place thumbs in slots directly under
arrows.
d. Pull open in opposite directions with
thumbs.
e. Place the filter in the holder recess area
at the bottom of the water filter holder.