Filter
Top Products
9
holding either button will allow you to scroll
continuously, slowly at first, and then to
accelerate to the rate of about three digits
per second. As the desired time setting
approaches, release the button and then press
repeatedly to advance one digit at a time.
The Automatic Shutoff Time (ASO) may be
programmed either before or during coffee
brewing. You may also re-program the ASO time
when brewing has been completed. If you do so,
the Automatic Grind & Brew
™
will automatically
account for any time that has already elapsed
after brewing. For example, if you set the ASO
for 40 minutes and 25 minutes have already
elapsed, the Grind & Brew
™
will shut off
automatically after 15 minutes (40 minutes
minus the 25 elapsed equals 15 minutes).
1. Insert the Water Filter
a. Remove the filter from polybag and soak
in cold tap water for 15 minutes.
b. Remove the water filter holder from
the coffeemaker by lifting it out of
the reservoir area with your thumb
and forefinger.
c. Grasp stem in one hand. Using thumb of
other hand, gently press down and pull
toward you. Compartment will flip open.
d. Place the filter in the holder and close the
water filter holder; you will hear a snap
indicating it is in place.
NOTE: Caution must be used when inserting
the charcoal filter. Improper placement in the
holder can cause tearing of the filter skin.
e. Hold the filter under cold running tap
water for 10 seconds to flush. You should
place the hole openings in the side of the
unit directly under the water stream.
f. Allow the filter to drain completely.
g. Replace the water filter holder in the
reservoir area of the coffeemaker, pushing
it all the way down to the base of the unit,
along the reservoir wall.
Note: We recommend changing the water filter
every 60 days or 60 uses, more often if you
have hard water.
Replacement water filters can be purchased
in stores or by calling customer service or
through the Cuisinart web site.
TURNING OFF GRIND
FUNCTION
To turn off the grinding function, press the
“Grind Off” button. An amber LED will be
illuminated. Then press the On button.
MAKING COFFEE
Before you make the first pot of coffee in your
new Cuisinart
®
Grind & Brew
™
Automatic
coffeemaker, we recommend operating the
coffeemaker once, using only water and a
paper filter. This will remove any dust or
residues which remain in the system from
the manufacturing process.
1. Fill the Water Reservoir
Open the reservoir lid by pushing the release
button and lifting up. Pour the desired amount
of water in the reservoir using the step water
indicator located at the rear of the reservoir.
2. Add Beans
Lift the grinder basket lid, using the recess on
either side. Fill the basket with the desired
quantity of beans.