Filter
Top Products
11
COVER
HINGE
TAB
SLOT
TO MAKE COFFEE WITH
PRE-GROUND BEANS:
Follow step #1 from Making Coffee
section on page 9, then continue as follows:
2. Open filter door. Add ground coffee to
our permanent or #4 basket paper filter.
Our recipe suggestion: Use 1 level scoop
of ground coffee per cup. Adjust the recipe
according to your individual taste.
NOTE: The maximum capacity for ground
coffee is 16 level scoops, using either a
paper or permanent filter. Exceeding that
amount may cause overflow if the coffee
is too finely ground.
3. Place filter basket lid in place. Close filter
door.
4. Follow instructions 5 through 8 from the
Making Coffee section.
5. Press the “Grind Off” button. When this
function is activated, an amber LED will be
illuminated. Then press the “ON” button.
CLEANING AND
M A I N T E N A N C E
COMPLETELY CLEAN AND DRY
ALL PARTS AFTER EVERY USE.
Always turn coffeemaker OFF and
remove the plug from the electrical outlet
before cleaning.
Open the reservoir lid*. Remove the grinder
basket lid by using the recessed area on
each side of the lid. Then remove Grinder
Basket. Open Filter Basket Door. Remove
Filter Basket Cover, Filter Basket and Filter
Basket holder.
The grinder basket, grinder basket lid, filter
basket and filter basket cover can be washed
in warm soapy water and rinsed thoroughly, or
cleaned in the upper rack of the dishwasher.
Dry all parts after every use.
Do not put any water in the unit once the
grinder basket has been removed. Wipe the
area under the grinder basket with a damp
cloth. If water gets into the grinder motor,
the motor may become damaged and
may malfunction.
Once clean, reverse the above steps.
Remove the carafe from the resting plate.
Discard any remaining coffee. The carafe and
lid can be washed in warm soapy water and
rinsed thoroughly, or placed in a dishwasher.
The carafe and carafe lid should be placed on
the upper rack only.
Do not use scouring agents or harsh cleansers
on any part of the coffeemaker.
Never immerse base unit in water or other
liquid. To clean base, simply wipe with a
clean, damp cloth and dry before storing.
Wipe resting plate with a clean, damp cloth.
Never use rough, abrasive materials or
cleansers to clean the resting plate. Do not
dry the inside of the water reservoir with a
cloth, as lint may remain.
* Note: Reservoir lid can also be removed for
easy cleaning. Open the lid 60˚ and gently pull
toward you. To replace, reverse steps.
DGB-600 IB-4336 9/19/02 3:19 PM Page 13