Filter
Top Products
11
chopped - like raisins or
nuts - add them last with
the mixed dry ingredients.)
To make cake mix:
Your food processor
work bowl is large enough
for the preparation of an
18.5-ounce packaged
cake mix.
Insert the metal blade and
add the cake mix to the
work bowl. Press the ON
button and while the
machine is running, add
the eggs and liquid through
the small feed tube and
process for 5 seconds.
Scrape down the sides
of the work bowl and
process 1 minute more for
maximum volume. Do not
remove the metal blade.
Insert a finger into the
underside of the blade
from the bottom of the
work bowl to hold the
blade in place while
emptying the batter.
Tip:
After emptying cake batter
or puréed soup from the
work bowl, replace the
bowl on the motor base
and PULSE once.
Centrifugal force will spin
the batter off the blade onto
the sides of the work bowl.
Remove the blade, and use
the spatula to scrape any
remaining batter from the
bowl.
PREPARING FOOD
FOR SLICING AND
SHREDDING
For disc assembly
instructions, refer to
Assembly Instructions.
Round fruits and
vegetables
Before processing onions,
apples and other large,
round fruits and vegeta-
bles, cut the bottom ends
flat to make the food lie
stable on the disc.
Place the food in the
feed tube, flat side down,
as far left as possible, to
prevent it from tilting when
being processed.
Choose fruits that are
firm and not too ripe.
Remove large hard pits
and seeds from fruits
before processing. Seeds
from citrus fruits need not
be removed. Remove the
rind before slicing or
shredding, if desired.
Whole peppers are
an exception
Remove the stem and cut
the stem end flat. Remove
the core and scoop out the
seeds. Leave the end
opposite the stem whole, to
keep the structure stiff. This
ensures round, even slices.
Large fruits like
pineapple
Cut the ends flat, cut in half
and either core or remove
the seeds. If necessary, cut
the halves into smaller
pieces to fit the feed tube.
Cabbage and
iceberg lettuce
Turn the head on its side
and slice off the top and
bottom, leaving a center
section about 3 inches (8cm)
deep. Remove the core,
then cut in wedges to fit the
feed tube. Remove the core
from the bottom and top
pieces and cut into wedges
to fit into the feed tube.
The optional 2mm and
1mm Slicing Discs are
excellent for slicing cabbage
for coleslaw.
If the fruit or vegetable
doesn’t fit, try inserting it
from the bottom of the feed
tube, where the opening is
slightly larger.
Pack the feed tube for
desired results.
For long slices or shreds,
cut the food in feed tube
widths and pack the
pieces horizontally.
For small, round slices or
short shreds from carrots,
zucchini and other long
vegetables, cut in feed
tube heights and pack
tightly upright.
Food should fit snugly, but
not so tightly that it prevents
the pusher from moving.
When slicing or shredding,
always use the pusher.
Never put your fingers
or a spatula into the
feed tube.
Never push down hard
on the pusher. Use light
pressure for soft fruits and
vegetables like bananas,
mushrooms, strawberries
and tomatoes, and for all
cheeses. Use medium
pressure for most food:
apples, celery, citrus fruit,
potatoes and zucchini. Use
firm pressure for hard
vegetables like carrots
and yams.
PRACTICING
SLICING AND
SHREDDING
1. Insert a slicing or
shredding disc, put the
cover on the work bowl,
and insert the food in
the feed tube.
2. Slide the pusher
into place, and apply
pressure to the pusher
while pressing down the
PULSE button. Release
the button as soon
as the food is sliced
or shredded.
03CU13537 DLC-2014N IB-5056 10/2/03 11:34 AM Page 13