Filter
Top Products
7
3. Turn the stem to the
right, so the locking
tabs are covered by
the metal supports
and a ‘click’ locks
the stem in place.
4. With the stem facing
down, place the
assembly over the
center hub. It should fit
snugly and rest on the
bottom of the work bowl.
5. Place work bowl cover
onto work bowl, with
the handle area just to
the left of center. Turn
counterclockwise to
lock onto work bowl.
6. Align Pusher with the
feed tube opening on
the work bowl cover and
slide the activating rod
down to the bottom.
7. Use the cord wrap
on the underside of
Housing Base to add or
remove cord.
8. You are now ready to
operate the machine.
THE MACHINE
FUNCTIONS:
PULSE
1. With the machine
properly assembled
and engaged, and
ingredients in the
work bowl, press the
PULSE button
repeatedly as needed.
ON (Continuous)
1. Properly assemble and
engage the machine.
2. To add ingredients
through the feed tube,
remove the pusher and
fill the feed tube as
directed (see preparing
for slicing or shredding).
3. Engage the pusher
and press the ON
button. The button light
will turn on and the
motor will start.
4. Press the Pusher firmly
down until all ingredi-
ents have passed into
the work bowl. Remove
the Pusher and refill
ingredients as needed.
When you engage the
Pusher again, the
unit will automatically
turn ON.
5. Press the OFF button
when finished.
DOUGH Button
1. Prepare the dough
ingredients and place
in work bowl.
2. Properly assemble and
engage the work bowl
cover and pusher.
3. Press the DOUGH
button and the light
will turn on.
4. Then press the ON or
PULSE buttons as
needed to process
DOUGH. The ON light
will turn on.
5. Press the OFF
button when finished.
OPERATING
INSTRUCTIONS:
Try chopping some practice
foods, such as a zucchini
or potato, before you
process food to eat. First,
cut the ingredients into 1-
inch pieces of even size
and length.
• Place the work bowl over
the center stem, with the
handle area just to the
left of center. Turn
counterclockwise to
lock in place.
• Insert the metal chopping
blade and put ingredient
pieces in the work bowl.
Put on the cover and turn
counterclockwise to lock
onto work bowl. Align the
pusher and the pusher’s
activating rod with the
corresponding openings
on the feed tube, and
push all the way down.
• Press and release the
PULSE button two or
three times. Each time the
blade stops, let the pieces
drop to the bottom of the
bowl before you pulse
again. This puts them in
the path of the blade each
time the motor starts.
• Using the pulse/chopping
technique, you get an
even chop without
overprocessing. Check
the texture frequently
by looking through the
cover. If you want a finer
chop, press and release
the PULSE button until
you achieve the desired
texture. Onions and other
food with a high water
content will quickly end
up as a purée unless
examined through the
work bowl after each
pulse to make sure they
are not overprocessed.
Try chopping other food,
like meat for hamburger
or sausage. Then make
mayonnaise, pastry or
bread, as described in
the following sections. To
obtain consistent results:
Be sure all the pieces you
add to the bowl are about
the same size.
Be sure the amount you
process is no larger than
recommended on the
inside cover of this booklet.
03CU13537 DLC-2014N IB-5056 10/2/03 11:34 AM Page 9