Filter
Top Products
4
ASSEMBLY
To use your Cuisinart
®
Blend and Cook Soupmaker, begin
by assembling the blender jar.
1. Place jar collar with blade
assembly (a) on a flat, sturdy
surface.
2. Carefully place the rubber gasket
(b) inside the jar collar.
3. Place the blender jar (c) on the
collar and turn clockwise until
tight.
Note: Blades are sharp. Handle
carefully.
4. Place lid (d) on jar and push until
secure. Place measuring cup (e) in
the lid opening and press into lid.
5. When placing jar onto base, be
sure arrow on jar collar, located
just below the handle, is aligned
with arrow on base (Fig. 1). Place
jar onto base, making sure the 3
interlocking pins on the underside
of the collar (Fig. 2) fit into the
rectangular rubber connector on
the base (Fig. 3).
NOTE: If jar does not sit flush on
base, do not force it! Remove jar and
slightly turn the clutch (Fig. 4), located
in the center of the top of the base.
CAUTION: Do not adjust jar collar
clutch after cooking, as it may be hot.
c.
b.
a.
d.
e.
Fig. 1
Fig. 3
Fig. 4
Fig. 2
HELPFUL REMINDERS
r 0ODFUIFDPWFSJTJOQPTJUJPOBEEJUJPOBM
ingredients can be added during blending by
simply lifting the measuring cup, adding ingredi-
ents through lid opening, and replacing the mea-
suring cup.
r
CAUTION: Be sure lid is on and measuring cup
is in lid opening when blending hot liquids
.
r
Lid should always be in place while the unit is on
.
r
CAUTION: Collar is hot when making soup.
Handle carefully.
r
Keep hands away from the underside of collar.
The surface will also be very hot.
r CAUTION: Do not place blender jar on base while
motor is running.
r %POPUUXJTUCMFOEFSDPMMBSGSPNCMFOEFSKBSXIFO
removing blender jar from base. Simply lift blender
jar from motor base.
r CAUTION: Do not put your hand on top of
blender while blending. Hot steam can come
through vents.
r 'PMMPX$MFBOJOHBOE.BJOUFOBODFJOTUSVDUJPOT
(page 6), prior to your first use.