Cuisinart TOB-155 Oven User Manual


 
6
BEFORE YOU BEGIN
Place your oven on a flat surface.
Before using your oven, move it two to four
inches away from the wall or from any objects
on the countertop. Do not use on heat-sensitive
surface.
OBJECTS SHOULD NOT BE STORED ON THE
TOP OF THE OVEN. IF THEY ARE, REMOVE
ALL OBJECTS BEFORE YOU TURN ON YOUR
OVEN. THE EXTERIOR WALLS GET VERY HOT
WHEN IN USE. KEEP OUT OF REACH OF
CHILDREN.
GENERAL GUIDELINES
Baking: The baking function is used as you
would normally use your large kitchen oven.
Broiling: Broiling can be used for beef, chicken,
pork, fish and more. Broiling can also be used
to top-brown casseroles and gratins.
Caution:
Aluminum foil is not recommended for covering
the broiling pan. Foil is extremely dangerous
when broiling fatty foods. Grease will
accumulate and may catch fire. We don’t
recommend the use of foil, but if foil is used to
cover drip tray, be sure foil is tucked neatly
around the pan and does not touch the walls or
heating rods. Never cover crumb tray.
Toasting: Always have the rack in rack position
B, as indicated in the diagram on page 11, for
even toasting. Always center your item/items in
the middle of the rack.
WARNING:
Placing the rack in the bottom
position or in the top position with the rack
turned upward while toasting may result in a fire.
Refer to rack position diagram for proper use.
Turning off the toaster oven broiler: The Start/
Stop button, when pushed the first time, will
start the oven. When pushed the second time,
during oven operation, the Start/Stop button will
turn the oven off. You will know the oven is off
when the LED light turns off.
USE AND CARE
Unwind the power cord. Check that the crumb
tray is in place and that there is nothing in the
oven. Plug power cord into the wall outlet.
PIZZA/BAKE
To bake, press the Bake button. The LED light
above the Bake button will turn on. The oven
temperature is preset for 150°F. Press the temp
button and the Up arrow to increase the
temperature or Down arrow to decrease to your
desired temperature. Note that the temperature
will increase and decrease in increments of 25ºF.
The temperature will read out on the clock
display. Press the Start/Stop button to start the
oven. When oven reaches the selected
temperature, the words “Temp. Ready” will be
displayed on the clock display, and the oven will
beep 5 times to let you know it is ready to bake.
The built-in timer can be used with this function.
See timer instructions below.
PIZZA
When baking pizza, please follow these guide-
lines:
• If baking fresh pizza, use the baking tray/pan
provided with this toaster oven.
• Sprinkle the pan with cornmeal or lightly spray
to make removing the pizza dough easier.
• Bake in rack position B.
• If baking a frozen pizza, you can place the
pizza directly on the rack in position B.
NOTE: AS A SAFETY MEASURE, THIS OVEN
WILL AUTOMATICALLY SHUT OFF AFTER
FOUR HOURS OF CONTINUOUS USE.
NEVERTHELESS, ALWAYS UNPLUG THE OVEN
WHEN NOT IN USE AND NEVER LEAVE THE
OVEN ON WHEN UNATTENDED.
BROIL
Note: When broiling, add approximately ¼ cup
water to the bottom of the baking pan/drip tray
to reduce sizzling and splatter. Place the broiling
pan in the drip tray.
Note: there are two
positions for the broiling pan so that a variety of
thicknesses of foods can be broiled. Also, the
oven rack can be turned up or down depending
on the thickness of the food being broiled. In
most cases the oven rack should be in the
higher position (position C – see rack position
diagram on page 11).
To broil, press the Broil button on the touchpad.
The LED light above the Broil button will turn on.
The temperature will automatically set to broil
temperature (500˚F). Temperature cannot be
changed. Press the Start/Stop button to start to
broil. Preheat oven for five minutes with door
closed. The clock display will indicate “brl” for
broil. After the five-minute preheat period, place
the broiling pan in the oven. Always leave door
ajar when broiling. To stop broil operation, press
the Start/Stop button.
Note: Never use oven glass dishes to broil.
The built-in timer can be used with this function.
See timer instructions below.