Filter
Top Products
3
3
After cleaning, reinstall the grill by aligning the
left and right edges of the grill with the vertical
grill guides and inserting the upper edge of
the grill into the slot in the top cap. Then pivot
and drop the bottom of the grill into the lower
locating slot.
Lift Here
Lift Here
Slide Bottom Out
Vertical Grill Guide
(Left Shown)
Grill Mount Groove
Electronic Keypad Cleaning
RV Model Only
The keypad and surrounding the plastic bezel
should be gently wiped with a lightly dampened
sponge or cloth. Any material that becomes
lodged between the pushbuttons and the
surrounding bezel may be removed by carefully
dabbing with a cotton swab or the edge of a
cloth. This will prevent the pushbuttons from
sticking. After cleaning, immediately dry the
keypad area with a soft cloth. Do not use any
abrasive materials to clean the keypad.
Grill Cleaning
RV Model Only
Remove the anodized aluminum grill by gently
grasping it on both ends and lifting up, then
rotate the bottom of the grill out of the lower
groove. The grill should be cleaned regularly by
hand-washing in hot water with a mild detergent
solution. Set the grill on a flat surface and wipe
only in the direction of the grill grain. Avoid
the use of abrasive materials such as steel
wool or scouring powder to prevent permanent
scratching or marring of the grill finish. Do not
use any cleaners containing ammonia as this
will damage the anodized aluminum finish. A
soft toothbrush or nylon bristle dish brush may
be used to clean the grill grooves.
Removing the Grill
(RV Shown)
Location of Mounting Groove
(RV Shown)
external and internal aluminum surfaces with a
sponge or cloth moistened with a mild detergent.
Rinse off with water, then remove all moisture
by wiping with a soft, dry polishing cloth. Always
wipe in the direction of the grain. Do not use any
abrasive substances on the intake panels, as
this may permanently mar the finish.
NOTE:
Restore the electronic controls to operating
status after cleaning the grill, filters and intake
panels. (Refer to the preceding section,
Securing the Electronic Keypad.) Dry and
reinstall all components prior to operating the
vent system.