Filter
Top Products
4
Turning on the Blower System
The blower system has four speed settings. The
speed is indicated by the number of lights that
glow on the blower speed indicator
C
.
Touch the “• +” key D to turn on the blower
system.
To increase the speed, touch and release the “• +”
key until the blower system is at the desired set-
ting.
Touch and release the “• -” key B on the control
panel to decrease the speed.
Touch and hold the “• -” key to turn the blower
completely off.
Blower Speed Indicator
NOTE: To conserve energy, the blower system
automatically turns itself off after four hours of
continuous operation.
Energy Saving Tips
Do not operate the fan at a speed higher than •
necessary to remove heat and smoke. Running at
too high a speed will draw in air from outside the
house, increasing heating and cooling costs.
Keep the filter system and hood surfaces free of •
grease and grime to improve efficiency.
Turn the fan off as soon as all smoke and odors •
have been cleared.
Select cookware of the proper size, material and •
construction for the cooking task. Always use lids
on cookware to retain heat and moisture.
Minimize the amount of liquid used to cook food.•
WARNING
Never operate the range hood without the filter(s) in
place. Also, do not operate the hood with grimy or
grease-laden filters. Personal injury, fire or damage to
the range hood could result.
Important Operating Tips
Always use the blower when using the cooktop or •
range.
Turn the blower on a few minutes before start-•
ing to cook to establish an airflow pattern in the
room.
Adjust the fan speed according to the volume and •
weight of the food you are cooking.
Shut nearby windows and doors, turn off ceiling •
fans and close nearby heating and air condition-
ing outlets to reduce air currents around the
hood.
Place your largest pots and pans on the back •
burners when possible.
In the interest of safety, heat oils and fats slowly.•
Operation
NOTE: After 30 hours of blower operation, the
control panel will flash. This signal means it is time
to clean the filter system (see page 5). Press the
timer reset key E to reset the timer. The lights
will stop flashing.
Main Power Switch
The main power switch is located behind the filter,
on the bottom of the hood, on the opposite side of
the control panel. See page 3 for the location.
Remove the filters and push in on the switch to
turn power on or off. The control panel is lit when
the main power switch is on.
Turning on the Lights
Touch the light key • A to turn on the lights.
Touch the light key again to turn them off.•
Control Panel
Operating Instructions
OFF LOW
MEDIUM
HIGH
A B C D E