Filter
Top Products
7
Installation Specifications
Top View - Downdraft ERV30[15] with Slide-In, Self-Rimming Installation,
3” Side Panels Installed
Top View - Downdraft ERV30[15] with Slide-In, Self-Rimming Installation,
3” Side Panels Removed
Rear wall or
countertop edge
countertop opening
29 1/4” (74.3 cm)
raised vent opening
27 1/2” (69.9 cm)
30 1/16” (76.2 cm)
cabinet opening
below countertop
below countertop
Cabinet face
Notch countertop
to width of cabinets
3/8” min. (1.0 cm)
countertop overhang
10” min. (25.4 cm)
to any combustibles
above counter both sides
19 3/4”
(50.2 cm)
to
22 3/4”
(57.8 cm)
19 3/4”
(50.2 cm)
2 5/8” (6.7 cm)
24 3/8”
(61.9 cm)
max.
Countertop front
Rear wall or
countertop edge
countertop opening
29 1/4” (74.3 cm)
raised vent opening
27 1/2” (69.9 cm)
30 1/16” (76.2 cm)*
cabinet opening
below countertop
below countertop
Cabinet face
Notch countertop
to width of cabinets
3/8” min. (1.0 cm)
countertop overhang
10” min. (25.4 cm)
to any combustibles
above counter both sides
22 3/4”
(57.8 cm)
2 5/8” (6.7 cm)
24 3/8”
(61.9 cm)
max.
Countertop front
Self-Rimming Installation with Raised Vent Cutout Options (Models DR30EIS and DR30EIFS Only)
Countertop height: 34 3/4” (88.3 cm) min.
36 7/8” (93.7 cm) max.
Countertop thickness: 1 5/8” (4.1 cm) max.
* To create a “built-in look” on the front of the cabinet, this dimension may be changed to 29 1/4” (74.3 cm), with the width at the
notches remaining 30 1/16”. This configuration is only for models DR30EIS and DR30EIFS with side panels behind door removed.
• A self-rimming countertop configuration is required for raised vent installation. On
installations with a raised vent, when sliding the range into position, it will stop when
the rear of the control panel or side panels contact the notches toward the front of
the countertop.
• The self-rimming installation of the DR30EI[F]S range and ERV30[15] raised vent
create a “built-in” look where the range trim overlaps the countertop on both sides
and the raised vent trim overlaps the countertop in back. The rear range trim will
partially cover the front of the raised vent chassis in back.