Filter
Top Products
17
Removing your oven’s convection filter...
When the oven is cool, put your fingers around the
edges of the filter and gently push up.
To clean the filter...
Soak it in hot, soapy water. Rinse well. You may also
place it in a dishwasher on the top rack. Dry the
filter before re-installing it.
Installing your oven’s convection filter...
Carefully hook the metal clips on the back of the
filter on the slots on both sides of the fan hole. Be
careful not to scratch the porcelain surfaces with the
back of the filter.
Replacing the Oven Light
WARNING
• To prevent an electrical shock hazard and/or personal
injury, make sure that power to the range has been
disconnected and that the light fixture is cool before
replacing the light bulb.
• Always ensure that the lens cover is in place when
using the oven. The lens cover protects the bulb
from breakage caused by high oven temperatures or
mechanical shock.
• Replacing the lens cover without lining up the cutout
with the light socket will damage the light fixture.
• Do not use a screwdriver to remove the lens.
Care and Cleaning
Light bulb replacement is considered a homeowner
maintenance operation. If the light does not work,
before replacing it, please consult the Problem
Solution Guide on page 18.
1. Replace the light bulb only with Dacor part
number 107112. See page 20 for ordering
information. IMPORTANT: Do not touch the
replacement halogen light bulb with your fingers.
Halogen bulbs are sensitive to the oils from your
hand. The oils from your hand will stick to the
bulb and may cause it to burn out faster than
normal.
2. Disconnect the range power cord from the elec-
trical outlet.
3. Hold your hand under the lens for support and
gently pry it loose using a spatula or table knife.
Pull the lens cover straight out.
4. Grasp the old bulb and pull it straight out of the
socket.
5. Using a glove, insert the new bulb into the
socket.
6. As you reinstall the lens cover, line up the cutout
on the inside rim with the light socket. Gently
press it into its original position.
7. Reconnect the power cord.
Light
fixture
Light
socket
Lens
Lens cutout
Bulb
1
2
3
4
5
7
6
Clips
Slots