Filter
Top Products
STEP 1 Move the wine dispensing system to a location
with a dedicated 120 Volt, 3-prong grounded
electrical outlet close by and adequate ventila-
tion.
STEP 2 Plug one end of the plastic gas tubing into the
inert gas connector on the back of the system
(see below).
STEP 3 Make sure the cable coming from the power
supply (black box) on the back of the system is
connected to the Power Input connector on the
back of the unit.
WARNING
Read all instructions in the use and care manual before
operation.
EXCESSIVE WEIGHT WARNING: Two people are required
to safely move this appliance.
Use only the gas regulator and argon gas cylinders in-
cluded with the system.
●
●
●
Instructions:
DYWS4 Wine Dispensing System
QUICK START
GUIDE
Part No. 107499 Rev. A
Gas and Electrical Connections
Plastic gas
tubing connects
here
Connect to 120 Vac, 60
Hz. electrical outlet
120 Vac power
cord connects to
power supply
Power
supply
Power supply output
connects here
1” (2.5 cm)
min.
Provide Proper Air Flow