Filter
Top Products
Wine Dispensing System
Page 2
STEP 4 Open the door on the front of the
system. Swing the spout cover to the
up position.
STEP 5 Make sure the power switch, located
on the left side of the bottle bay, is
slid all the way down, to the OFF
position.
STEP 6 Find the gas regulator assembly
that comes with the system. Make
sure the regulator adjustment knob
is turned all the way in the OFF
direction.
STEP 7 Connect the gas supply line from
the wine dispensing system to the
gas connector on the regulator as-
sembly.
STEP 8 Remove the plastic cap from the
top of the argon gas cylinder.*
STEP 9 Insert the top of the gas cylinder
into the bottom of the gas regula-
tor assembly and turn it clockwise,
by hand, until it is snug. Do not
use a wrench or overtighten.
STEP 10 Turn the regulator knob in the ON
direction until it stops.
Regulator
adjustment
knob
Gas supply
line from wine
dispensing
system
Regulator
assembly
Argon
gas
cylinder
ON
SERVICE MODE
RESERVED
OFF
Spout cover
STEP 11 Plug the power cord into the grounded 120 Vac., 60 Hz. electrical outlet.
STEP 12 Slide the power switch all the way up to the ON position. When powering on, the sys-
tem will run through a series of diagnostics, which will take several seconds. If the
control panel is locked, perform the following steps:
• Slide the power switch down one notch to the SERVICE MODE position (see dia-
gram at top of page).
• Push WineStation Service next to any of the displays.
• Push Exit.
• Slide the power switch up to the ON position.
*IMPORTANT: The required argon
gas cylinder is not shipped with
the system and must be ordered
separately. Order on-line at www.
everythingdacor.com or by calling
Dacor Customer Service at (800)
793-0093 ex. 2822. Your first gas
argon gas cylinder is provided free
of charge.