Dacor DYWS4 Refrigerator User Manual


  Open as PDF
of 4
 
Quick Start Guide
Page 3
STEP 13 Openawinebottleandplaceitonaat,dry
surface.
STEP 14 Insert the included head selection tool into
the bottleneck to determine the correct (color
coded) gasket size.
STEP 20 Carefully insert the dispensing head (with the
pick up tube still attached) into the bottle.
STEP 21 While pressing down on the head with one
hand, tighten the collar with your other hand.
Useonlytwongersandyourthumbtoturn.
The gasket will expand inside the bottleneck,
sealing and holding the bottle from the inside.
Do not over-tighten.
STEP 22 While holding the head and bottle over a
table or countertop for safety, grasp the top of
the head without touching the bottle. Lift the
head up 2 inches and shake slightly to check
that the bottle is snuggly attached. If the
bottle comes loose, retighten the head.
Head Selection
Tool
Green
Red
White
Insert
pick-up
tube
STEP 15 If you do not have a dispensing head with the
correct color gasket installed:
• Remove the gasket nut on the bottom of
the head by turning it counter-clockwise.
• Replace the gasket with the correct color
and replace the gasket nut.
STEP 16 Insert a clean pick up tube into the bottle. (It
is normal for the upper end of the tube to ex-
tend beyond the tip of the bottle at this point).
STEP 17 Insertthepickuptubermlyintotheopening
on the bottom of the head.
STEP 19 Fully un-tightened the head collar until it
stops.
Gasket
Dispensing
head
Gasket
nut
 previous