Filter
Top Products
4
5
Cleaning and Maintenance
To Remove the Filter(s):
The filter(s) A are located on the bottom of the hood,
directly above the cooking surface.
Hold the filter in place with one hand and push back on
1.
the release lever B with the other.
While pushing back on the release lever, lower the filter
2.
out of the hood. On hoods with more than one filter,
remove and clean all of the filters.
To Clean the Filter(s):
Hand wash the filter(s) in hot water with a mild detergent
solution or dishwashing soap. Or you can place them in an
automatic dishwasher. Dry the filter(s) completely before
reinstalling.
To Reinstall the Filter(s):
Insert tabs on the end of the filter opposite the release 1.
lever into the slots toward the back of the hood (above
the hood rim). The release lever must be facing down.
Push back on the release lever while sliding the free 2.
end of the filter into the filter opening.
Release the lever.
3.
Proper cleaning is necessary to ensure safe operation
and maintain hood performance and appearance. The
frequency of cleaning should be adjusted according to the
type and amount of cooking. Best results will be achieved
by cleaning soiled components as soon as possible.
Cleaning Stainless Steel Surfaces
Clean stainless steel surfaces with a mild solution of
detergent or dishwashing soap and warm water. Rinse and
dry with a soft, lint-free cloth.
You may also use Dacor Stainless Steel Cleaner. Use it
according to the directions on the package.
Cleaning the Light Lens
Use a mild glass cleaner to remove smudges on the light
fixture lens. You can also clean it with Dacor Cook Top
Cleaning Creme. Use it according to the directions on the
package.
Cleaning the Filter(s)
Clean the filter a minimum of every two months. To help
remind you to clean the filter(s), the CLEAN FILTER light
will come on after 50 hours of fan operation. See page 4 for
instructions on how to reset the light.
WARNING
To avoid the risk of fire, electric shock or personal
injury:
Turn off power to the hood at the circuit breaker panel •
or fuse box before cleaning.
Clean the hood only in the manner specified.•
Use only the types of cleaning solutions specified in this •
manual.
Thoroughly dry the filter(s) immediately after cleaning.•
Turn off the cooktop or range and make sure that the •
appliance and range hood are cool before cleaning.
To avoid damage to the fan, do not reinstall damaged •
filters (see page 6 for replacement part numbers).
CAUTION
Always wipe stainless steel (silver colored) surfaces •
with the grain. To prevent scratching, do not use
abrasive cleaners or scrubbers on stainless steel or
glass surfaces.
Cleaning
A
B