Filter
Top Products
14
Installation Instructions
Verifying Proper Operation
For stainless steel ovens, peel off the protective layer of 1.
plastic that covers the stainless steel surfaces.
Remove any packaging from inside the oven(s).2.
Slide the oven racks onto the supports inside the oven 3.
chamber(s) according to the use and care manual.
Turn on power to the oven at the circuit breaker or fuse 4.
box.
Set the clock according to the use and care manual.5.
NOTE
For double ovens, test oven operation for both the upper
and lower ovens.
Press the 6. BAKE key on the control panel. The default
bake temperature should appear on the display.
Press 7. START. After approximately three (3) minutes,
the lower heating element should glow red through the
glass.
Press 8. CANCEL/SECURE.
Press the 9. BROIL key on the control panel. The default
broil temperature should appear on the display.
Press 10. START. After approximately three (3) minutes,
the upper heating element should glow red. On some
ovens the element is behind the glass panel on the
ceiling of the oven.
If the oven does not operate properly, follow these 11.
troubleshooting steps:
Verify that power is being supplied to the oven.•
If power is being properly supplied, turn off power at the •
circuit breaker or fuse box an check the electrical con-
nections.
Turn on power and repeat the above heating test.•
If the appliance still does not work, contact an authorized •
Dacor service company. If you are unable to locate
a service representative, please contact the Dacor
Customer Service Team at (800) 793-0093, or visit us
on the web at www.Dacor.com.
Do not attempt to repair the appliance yourself. If you •
need service, be sure to have the model and serial
numbers available when you call. See page 3.
Reinstalling the Oven Door (Cont)
To re-install the oven door on model EORS136:
WARNING
To avoid personal injury or damage to the door from
it falling off its hinges:
Make sure that the notch on the bottom of each hinge •
rests on top of the lower lip of each hinge receptacle
before attempting to open the oven door.
Rotate the hinge locks toward the front of the range •
immediately after installation of the door.
Grasp the oven door on opposite sides and hold it at a 1.
15° angle from the front of the oven. Slide the hinges
into the hinge openings, resting the bottom of the hinge
arms on the hinge receptacles. Continue to hold the
door at a 15° angle with one hand while pushing in on
each of the bottom corners of the door. Push until the
notch on the bottom of each hinge slips over the lower
lip of each hinge receptacle.
Lower the door to the fully opened position.2.
Rotate the two hinge locks toward the oven.3.
Slowly and carefully open and close the door completely 4.
to ensure that it is properly installed.
Notch on bottom
of hinge
Lower lip of
hinge receptacle