Filter
Top Products
6
Install the Anti-Tip Bracket
Locate the anti-tip foot on the back of the range and turn 1.
it until the bottom of it is 1/16” (2 mm) off the floor.
Backguard Installation
If installing a backguard other than the standard 6-inch
version, install it before pushing the range into place. Install
it according to the installation instructions accompanying
the backguard.
Level and Adjust the Range Height
Raise or lower the range until it is the same height as 1.
the counter-top. To adjust the height, turn the foot on the
bottom of each leg as shown below.
Use a level to make sure that the range does not tilt 2.
front to back or side to side. Re-adjust the legs as
necessary.
Verifying the Package Contents
Unpack the range and verify that all required parts have
been provided. If any item is missing or damaged, please
contact your dealer immediately. Do not install a damaged
or incomplete appliance. The customer must report
cosmetic issues immediately to the dealer or builder.
WARNING
Observe all governing codes and ordinances during •
planning and installation. Contact your local building
department for further information.
I• f the gas or electric service provided does not meet
the product specifications, do not proceed with the
installation. Call the selling dealer, the gas supplier or
a licensed electrician.
This appliance must be installed by a licensed plumber •
or gas fitter when installed within the Commonwealth
of Massachusetts.
Installation Instructions
Back of Range
Anti-Tip Foot
up
down
Parts List
Anti-tip bracket•
2 grates•
3 standard burner caps (2 large, 1 small)•
3 standard burner rings (2 large, 1 small)•
1 dual burner ring•
1 outer dual burner cap•
1 inner dual burner cap•
3 oven racks•
Use and care manual•
Ignitor cleaning brush•
Lens pry stick•
Stainless steel cleaner•
See the use and care manual for a list of optional parts and
accessories.