Dacor PMD30 Microwave Oven User Manual


 
18
CLEANING AND CARE
EXTERIOR
The outside surface is precoated metal and plastic. Clean
the outside with mild soap and water; rinse and dry with
a soft cloth. Do not use any type of household or abrasive
cleaner.
STAINLESS STEEL SURFACE
(SELECT MODELS)
The exterior should be wiped often with a soft damp cloth
and polished with a soft dry cloth to maintain its beauty.
Always wipe in the direction of the grain. There are also
a variety of products designed especially for cleaning and
shining the stainless exterior of the oven. We recommend
that the cleaner be applied to a soft cloth and then carefully
used on the stainless exterior rather than sprayed directly on
to it. Follow package directions carefully.
FRONT SIDE OF THE DRAWER
Wipe the window on both sides with a soft damp cloth to
remove any spills or spatters. Metal parts will be easier to
maintain if wiped frequently with a soft damp cloth. Avoid
the use of spray and other harsh cleaners as they may stain,
streak or dull the door surface.
TOUCH CONTROL PANEL
If desired, the touch pads may be deactivated before cleaning.
See the Control Lock information on page 16 of this manual.
Wipe the panel with a cloth dampened slightly with water
only. Dry with a soft cloth. Do not scrub or use any sort of
chemical cleaners. Close door and follow directions on page
16 for turning Control Lock off. Touch STOP/CLEAR.
INTERIOR
Cleaning is easy because no heat is generated to the interior
surfaces; therefore, there is no baking and setting of spills or
spattering. To clean the interior surfaces, including drawer
sealing surfaces, wipe with a soft damp cloth. DO NOT USE
ABRASIVEORHARSHCLEANERSORSCOURING
PADS. For heavier soil, use mild soap; wipe clean with a soft
damp cloth. Do not use any chemical oven cleaners.
MICROWAVE IN A DRAWER GUIDES
Remove the food crumbs from the Drawer guides. Wipe with
a soft dry cloth in order to keep the Microwave in a Drawer
opening and closing smoothly.
WAVEGUIDE COVER
ATTENTION
The waveguide cover, located on the inside
top of the Microwave area, is made from mica, so it
requires special care. Keep the waveguide cover clean to
assure good microwave performance. Carefully wipe with
a soft damp cloth any food spatters from the surface of
the cover immediately after they occur. Built-up splashes
may overheat and cause smoke or possibly catch re. Do
not remove the waveguide cover.
ODOR REMOVAL
Occasionally, a cooking odor may remain in the Drawer. To
remove, combine 1 cup water, grated peel and juice of one
lemon and several whole cloves in a 2-cup glass measuring
cup. Boil for several minutes using 100% power. Allow to
set in the Microwave in a Drawer until cool. Wipe interior
with a soft cloth.