Filter
Top Products
2
The operating temperatures of the appliance
range from the low forties to the mid fifties.
Do not install the appliance where the
temperature will go below 55°F (13°C) or above
90°F (32°C).
NOTES:
As with any refrigeration product, there is a
slight temperature variance at different locations
within the cabinet.
Temperatures at the bottom of the cabinet will
be cooler than temperatures at the top of the
cabinet.
Position your wine inventory accordingly (i.e.
white wines in the cooler zones and red in the
warmer zones).
When the temperature is adjusted, allow 24
hours for the unit to stabilize.
Beverage Cooler
To set the control, turn it to the midpoint setting
(approximately 45ºF). Once the beverage cooler
is loaded, allow at least 24 hours before making
any adjustments to the initial setting.
The interior light makes it easy to view your
wine/beverage labels and enhances the display
of your collection.
When the switch is in the OFF position, the
light comes on only when the door is opened.
When the switch is in the ON position, the light
remains on continuously for your maximum
viewing pleasure. For best viewing do not store
a bottle on the top shelf directly under the light.
Remember to turn off the light when it is no
longer needed.
Tempered glass shelves in the beverage cooler
unit are removable for easy cleaning or for
storing larger items.
To remove a shelf, open the door completely to
avoid potential damage to the gasket. Lift up on
the back of the shelf slightly. Tilt the shelf to one
side at an angle while pulling forward.
To replace a shelf, open the door completely
to avoid potential damage to the gasket. Tilt the
shelf to one side at an angle and slide toward
the back wall, placing one side onto the shelf
support. Place the other side onto the opposite
shelf support. Ensure rear locking tabs are
engaged. When installed properly, the shelf will
not slide forward when gently pulled.
Wine Cooler Temperature Controls
Temperature Control Interior Light and Switch
Glass Shelves
Place in slots when replacing the shelf
Wine Steward
The RED WINE setting will provide a storage
temperature of approximately 55ºF (13ºC),
which is optimum for the storage for red wine.
The WHITE WINE setting will provide a storage
temperature of approximately 45ºF (7ºC), which
is optimum for white wine.
To set the control, turn it to the RED WINE
setting. Once the bottles are loaded, allow at
least 24 hours before making any adjustments
to the initial setting.
Beverage Cooler Temperature Controls
To remove, lift up on the back of the shelf
Tilt the shelf at an angle while removing or replacing
The bottom full extension drawers pull out so
bottles can conveniently be added or removed.
The upper full extension slide can be removed
for magnums or larger bottles.
To remove:
1. Pull the full extension drawer out to the STOP
position.
2. Push the tab on right drawer guide down
while pulling the tab on left guide up, and pull
the drawer out.
To replace:
1. Push the drawer slide arm back into the unit.
2. Pull the small slide sub assembly completely
forward.
3. Insert the sides of the drawer back into the
guides.
4. Push until the tabs lock into place.
Removing Full Extension Drawers
Tab (push tab down on right
drawer guide, pull tab up on
left drawer guide)
Pull small slide sub assembly
completely forward
To replace, push drawer slide
arm back into unit
NOTE:
Make sure the tabs on the full extension drawer
guides are fully engaged before loading any
bottles. Pull the drawers out all the way to the
STOP position and push back in several times
to make sure locking tabs are properly engaged.