Filter
Top Products
4. Method to reduce the gap between the door seal and the oven front surface.
(1) To reduce gap located on part A .
Loosen two screws on stopper hinge top, and then push the
door to contact the door seal to oven front surface.
Tighten two screws.
(2) To reduce gap located on part B .
Loosen two screws on stopper hinge under, and then push
the door to contact the door seal to oven front surface.
Tighten two screws.
NOTE : A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm
2
.
14