Filter
Top Products
READ ALL SAFETY INFORMATION BEFORE USING
IMPORTANT SAFETY INFORMATION
INSTALLATION INSTRUCTIONS
LOCATION
1
Improper use of the grounding plug can result in a risk of
electric shock. Consult a qualified electrician or serviceman
if the grounding instructions are not completely understood,
or if doubt exists as to whether the appliance is properly
grounded.
WARNING
This appliance must be grounded. In the event of an electrical
short circuit, grounding reduces the risk of electrical shock by
providing an escape wire for the electrical current. This appli-
ance is equipped with a cord having a grounding wire with a
grounding plug. The plug must be plugged into an outlet that
is properly installed and grounded.
DO NOT USE AN EXTENSION CORD
Use an exclusive wall outlet. Do not connect your refrigerator
to extension cords or together with any other appliance in the
same wall outlet.
IMPORTANT WARNING
An empty refrigerator can pose a threat to children. To render
the unit harmless we strongly recommend removing the door
prior to disposal. Before you throw away your old refrigerator
or freezer:
• Take off the doors.
• Leave the shelves in place so that children may not easily
climb inside.
SAVE THESE INSTRUCTIONS!
GROUNDING INSTRUCTIONS
Remove exterior and interior packaging, wipe the
outside thoroughly with a soft dry cloth and the inside with a
wet, lukewarm cloth. Avoid placing the unit in a narrow recess
or near any heat source, direct sunlight, or moisture. Let air
circulate freely around the unit. Keep the rear of the refrigera-
tor 5 inches away from the wall.
LOCATION
1) Select a place with a strong, level floor.
2) Allow 5 inches of space between a wall and the back of the
refrigerator, and 1 to 2 inches of space between a wall and
a refrigerator side.
3) Avoid direct sunlight and heat. Direct sunlight
may affect the acrylic coating on the refrigerator exterior.
Heat sources nearby will cause higher electricity consump-
tion.
The refrigeration system in this refrigerator is a “Frost Free”
system. This type of system requires no user intervention (i.e.
defrosting) other than selecting required cooling temperatures
and the usual care and
maintenance.
To avoid vibration, the unit must be leveled. This is accom-
plished by adjusting the 2 front leveling legs located under the
refrigerator. (see Figure on the right)
NOTES:
• This appliance is intended for FREE-STANDING
INSTALLATION ONLY, and is NOT intended to be built-in.
• This appliance is approved for INDOOR USE ONLY and is
NOT intended for outdoor operation. Do not place the
refrigerator in your garage or other places that are not within
the operating temperature range.
IMPORTANT: Install this appliance in an area where the ambi-
ent temperature is between 55°F (13°C) and 90°F (32°C). If
the temperature around the
appliance is too low or high, cooling ability will be affected.
Bottom of Unit
Leveling Legs
Turn clockwise to
lower the unit
Turn counter-
clockwise to
raise the unit.
Use pliers or wrench to adjust the
leveling legs