DCS RGS-485GD Cooktop User Manual


 
CARE AND MAINTENANCE
26
FRAME, SIDES, DOOR EXTERIOR, HEAT DEFLECTOR
These parts are made of stainless steel,follow the directions for the Backguard (above). Take care when
cleaning the door top, and do not let water or cleaners run down the vents. If water or cleaners spill
into the vents,they may streak the glass inside the door.
DOOR GASKET
Use warm soapy water only (no commercial cleaner) and rub softly, blot dry with a cloth. Do not rub.
Do not remove or damage the mesh.
TO REPLACE THE LIGHT BULB:
1) Turn off circuit breaker.
2) Be sure the oven light bulb switch is in the off position. The bottom of the switch is pressed in.
Let the cover and the bulb cool completely.
3)Remove the light cover. Turn the cover to the left (counterclockwise) to unscrew it.
4)Remove the burnt out bulb. Replace it with a 40 watt appliance light bulb only.
5)Replace cover. Turn circuit breaker back on (See Caution).
CAUTION:
Be sure the oven light switch is in the OFF position and the cover is cool. If the
bulb comes loose from the base, turn off the power to the oven at the circuit
breaker panel before attempting to remove the bulb base from the socket.
POWER FAILURE
The broiler and oven burners cannot be turned on during a power failure. To light the cooktop burners,
turn the control knob to “LITE”,hold a lighted match to the port ring. After the flame is burning all the
way around the burner, adjust the flame. It is necessary to light each burner separately,each time you
want to use it.