DCS UT624 Beverage Dispenser User Manual


 
5
INSTALLATION
HOW TO INSTALL YOUR OUTDOOR REFRIGERATOR/BEER DISPENSER
24” Outdoor Beer Dispenser
• 120V 60Hz • UL approved
• 1800 watt • Available freestanding or built-in
• 3 wire • Drip tray
• 15 amp circuit
24” Outdoor Refrigerator
• 120V 60Hz • UL approved
• 1800 watt • Interior space 6.1 cu ft
• 3 wire • Available freestanding or built-in
• 15 amp circuit • Auto defrost
AC Interface
AC Interface
ELECTRICAL CONNECTION:
Check serial plate for correct power supply. Use only electrical power supply as specified on your appliance
serial nameplate. Do not use an extension cord!
WARNING!
Do not splash or spray water from a hose onto the refrigerator! Doing so may cause an electrical shock, which may
result in severe injury or death.
GROUNDING METHOD
This product is factory equipped with a power supply cord that has a three-pronged grounded plug. It must be
plugged into a mating grounding type receptacle in accordance with the National Electrical Code and
applicable local codes and ordinances. If the circuit does not have a grounding type receptacle, it is the
responsibility and obligation of the customer to exchange the existing receptacle in accordance with the
National Electrical Code and applicable local codes and ordinances. The third ground prong should not, under
any circumstances, be cut or removed. All UL listed refrigerated products are equipped with this type of plug.
A ground fault circuit interrupter electrical receptacle is to be used to supply electrical power to the refrig-
erator for outdoor applications. Contact an electrician if you need to install one to supply electrical power to
your outdoor refrigerator.
POWER REQUIREMENTS:
Note:
The plug shown is for 115V units. The
prongs on your model may be different
than the one shown if your unit is other
than 115 volts.
Grounding Type
Wall Receptacle
Power Supply Cord
with 3-Prong
Grounding
Plug