DCS WOSD-230 Oven User Manual


 
15
OPERATING INSTRUCTIONS (Food Probe)
USING THE FOOD PROBE:
You may use the food probe to cook
to the internal temperature of a food
product, for more precise cooking
(upper oven only on double oven).
1. Insert the tip of the food
probe into the food. The first
one inch of the probe is
where the food temperature
will be measured, so position
it accordingly into the center
of the meatiest portion, one
inch from bone. Do not
position it next to a bone in
the meat,since this will affect
the temperature.
2. Place the food product with
the probe already inserted in
the oven and insert the plug
of the food probe into the
receptacle located at the top
right front of the oven.
3. Approximately 5 seconds after inserting the probe’s plug into the oven receptacle,the flashing
word Probe will show in the display along with rapid beeping.Press the Probe key and enter a
probe cooking temperature between 100°F to 200°F using the number keys.
4. The display will show the actual temperature of the food.
5. Approximately 5 seconds after entering the probe cooking temperature the words Conv.Bake
and Roast will flash along with rapid beeping.The control is prompting you to enter a cooking
mode,so select the mode you wish to use;Bake,Conv.Bake or Conv. Roast (convection modes
available in upper oven only on Models WOS-227 and WOS-230.)
6. Enter the temperature at which you want the oven to cook. Do not confuse this with the
internal food temperature (the probe temperature) you set earlier.This will be the temperature
of the oven to actually cook the food.Use the number keys to enter a temperature setting from
100°F to 550°F.
7. The oven will heat to the desired cooking temperature and cycle on & off until it reaches the
probe set temperature.The actual probe temperature shows in the display.When the probe set
temperature is reached,End will show in the display and the oven will chime 4 times,the actual
probe temperature will flash and the oven will automatically turn off.The oven will chime once
every minute for the next 10 minutes. As the food cools, the flashing probe temperature will
show the actual food temperature.
8. Be careful not to burn yourself when removing the food probe plug from the oven receptacle.
Once removed,the probe temperature digits will go blank.
9. Wash the stainless steel end of the food probe in hot soapy water but Do Not get the plug end
of the probe wet. When not in use, store in a dry place. It is not recommended to leave the
probe in the oven when not in use.
WARNING:
Do not leave the food probe in the oven during the self cleaning as the probe
will be destroyed.