Filter
Top Products
PAGE 6
Things to be done for energy saving
• Do not leave the doors of your refrigerator
open for long periods of time.
• Do not put hot food or drinks in your
refrigerator.
• Do not overload your refrigerator. This
restricts effective air circulation in the
refrigerator.
• Do not install your refrigerator under direct
sunlight or near heat emitting appliances
such as ovens, dishwashers or radiators.
Pay attention to keep your food in closed
containers.
• For refrigerators with a freezer
compartment; You can store maximum
amount of food items in the freezer when
you remove the shelf or drawer of the
freezer. The energy consumption value
stated for your refrigerator has been
determined by removing the freezer shelf
or drawer and under maximum load. There
is no harm in packing a shelf or drawer
with a variety of different shapes and sizes
of food to be frozen.
• Thawing frozen food in the fridge
compartment will provide both energy
saving and preserve the food quality.
Before operating your refrigerator
Before using your refrigerator please note
the following:
• Is the interior of the refrigerator dry and
can the air circulate freely at the rear of it?
• Clean the interior of the refrigerator as
recommended in the “Maintenance and
cleaning” section.
• Plug the refrigerator into the wall socket.
When the fridge door is open the fridge
compartment interior light will come on.
• You may hear a noise as the compressor
starts up. The liquid and gases sealed
within the refrigeration system may also
give rise to noise, even if the compressor
is not running, this is quite normal.
• The front edges of the refrigerator may feel
warm. This is normal. These areas are
designed to be warm to avoid
condensation.
Electrical connection
Connect your refrigerator to a grounded
socket which is protected by a fuse with the
appropriate capacity.
Important
The connection must be in compliance with
national regulations.
• The power cable plug must be easily
accessible after installation.
• The specified voltage must be equal to
your mains voltage.
Installation
Please remember that the manufacturer
shall not be held liable if the information
given in the instruction manual is not
followed.
Points to be considered when re
transporting your refrigerator
1. Your refrigerator must be emptied and
cleaned prior to any transportation.
2. The shelves, accessories, crisper etc.
In your refrigerator must be fastened
securely with adhesive tape to protect
against any jolts before repackaging.
3. Packaging must be tied with thick tape and
strong rope and the transportation
guidelines printed on the package must be
followed.
A damaged power cable must be
replaced by a qualified electrician.
A damaged refrigerator must not
be operated before it is repaired!
There is danger of an electric
shock!
Extension cables and multiway plugs
must not be used for connection.