Filter
Top Products
Page 11
Removing the inner door glass. (Where fitted)
• The glass may be removed for cleaning pur-
poses by removing the two screws which hold
it in place.
• It is now possible to clean the inside of the
outer glass if required.
• Wash the glass in hot soapy water, rinse and
dry.
• Re-assemble by carefully locating the rubber
seal in the embossed groove before fitting the
glass. The glass is marked
“THIS SIDE TOWARDS OVEN”.
• Re-fit the two securing screws.
Removing the side racks and shelves
• The side racks and shelves may be removed for
cleaning purposes.
• Slide the shelf out fully against the shelf stop.
• Lift the shelf slightly and slide it out
• The side racks may be removed by pulling the
bottom stay slightly downwards thereby dislodg-
ing it from the retainer at the bottom centre. Lift
the racks free of the retaining slots in the oven
wall.
• Replace in reverse order of disassembly.
Maintenance
Grasp the open door on
both sides near the hinges
Flip the retainer clasps up
and over the hook on the
upper hinge arm .
Maintain upward pressure
on the door to prevent the
clasps from disengaging
Lift the door upwards and
outwards until it is free of
the hinge housing
After cleaning ,refit the door
in reverse order.
Lift-off oven door
The oven door may be removed to improve oven access during cleaning
Grasp the open door on
both sides near the hinges