Filter
Top Products
Page 8
NOTE: THE WARRANTY DOES NOT COVER THE REPLACEMENT
OR REPAIR OF RUSTED OR CORRODED PLATES.
Caring for solid plates
• Before using the plates for the first time, switch them on for about 4 minutes at the highest
setting. This allows the factory applied protective coating to burn in. Fumes will be evidenced
during this operation but this is normal.
• To prevent blotchy discolouration and corrosion, moisture from spatters and spills should be
cleaned off immediately.
• To clean the plates, wipe them with a damp cloth or nylon pad. A little liquid detergent may be
used. Do not use metal scourers or sharp metal objects to clean the plates.
• After cleaning, dry the plates by switching them on for a short while.
• To prevent rust, periodically apply some sewing machine oil or electrical hotplate polish -
available from Defy Service Centres. Extra attention is required in areas of high humidity or in
close proximity to the sea.
SWITCH THE PLATE ON FOR A
SHORT PERIOD TO DRY
TO CLEAN THE PLATE
WIPE IT WITH A DAMP
CLOTH OR NYLON SCOURING PAD
DO NOT
DO NOT
USE ONE POT ON TWO PLATES
USE POTS THAT ARE SLIGHTLY
BIGGER THAN THE PLATES
TO INHIBIT CORROSION, PERIODICALLY APPLY
ELECTRICAL PLATE POLISH,
SALT-FREE VEGETABLE OIL
OR SEWING MACHINE OIL TO THE PLATE
TO CONSERVE ENERGYAND AVOID SPILLS
KEEP A LID ON THE POT
DO DO NOT
DO NOT
USE A POT ON AN UNMATCHED PLATE
DO NOT USE A POT WITH AN UNEVEN BASE
DO NOT USE A POT WITH A DIRTY OR WET BASE