PAGE 4 OF12
Check the oven for:
x A damaged, misaligned or bent door.
x Damaged door seals and sealing surfaces.
x Broken or loose door hinges and latches..
x Dents inside the cavity or on the door..
1. If there is any damage, do not operate the oven and contact qualified service personnel.
2. Make sure that all the packing materials are removed from the inside of the door.
3. The microwave oven must be placed on a flat and stable surface, strong enough to hold its weight and the
heaviest food likely to be cooked in the oven.
4. Do not place the oven where heat, moisture, or high humidity are generated, or near any combustible materials.
5. The oven must have sufficient ventilation to operate correctly.
Allow a space of 20cm above the oven, 10cm at back and 5cm at both sides.
6. Do not cover or block any openings on the appliance.
7. Do not remove the feet.
8. Do not operate the oven without the glass tray, the roller support, and the shaft in their proper positions.
9. Make sure that the power supply cord is undamaged and does not run under the oven or over any hot or sharp
surface.
10.The socket must be readily accessible so that it can be easily unplugged in an emergency.
11. Do not use the oven outdoors.
SPECIFICATIONS.
Power Consumption: 230V~50Hz, 1500 W (Microwave)
1300 W (Grill)
Microwave output: 1000 W.
Operation Frequency: 2450 MHz.
Outside Dimensions: 300mm (H) × 539mm (W) × 474mm (D)
Oven Cavity Dimensions: 240mm (H) × 376mm (W) × 404mm (D)
Oven Capacity: 34 Litres.
Cooking Uniformity: Turntable System.
Net Weight: Approx.17.8.kg
INSTALLATION.
RADIO INTERFERENCE.
Microwave ovens can cause radio and TV interference.
This may be reduced or eliminated by taking the following measures:
1. Clean the door and sealing surfaces of the oven.
2. Reorient the receiving antenna of the radio or the television.
3. Relocate the microwave oven with respect to the receiver.
4. Move the microwave oven away from the receiver.
5. Plug the microwave oven into a different outlet so that the microwave oven and receiver are on different branch
circuits.