Filter
Top Products
Page 7
Removing the inner door glass
.
• The glass may be removed for cleaning purposes by
removing the two screws which hold it in place.
• It is now possible to clean the inside of the outer
glass if required.
• Wash the glass in hot soapy water, rinse and dry.
• Re-assemble by carefully locating the rubber seal in
the embossed groove before fitting the glass. The
glass is marked.
“THIS SIDE TOWARDS OVEN”.
• Re-fit the two securing screws.
Removing the side racks and shelf
• The side racks and shelf may be removed for cleaning
purposes.
• Slide the shelf out fully against the shelf stop.
• Lift the front slightly and slide it out.
• The side racks may be removed by pulling the retainer
rod slightly downwards thereby dislodging it from the
retainer lug at the bottom centre. Lift the racks free of
the retaining slots in the oven wall.
• Replace in reverse order .
Maintenance.
Grasp the open door on
both sides near the hinges
Flip the retainer clasps up
and over the hook on the
upper hinge arm .
Maintain upward pressure
on the door to prevent the
clasps from disengaging.
Lift the door upwards and
outwards until it is free of
the hinge housing.
After cleaning, refit the door
in reverse order.
Lift-off oven door.
The oven door may be removed to improve oven access during cleaning.
Grasp the open door on
both sides near the hinges.