9
Versa Drawer™ Refrigeration Units
Deleld · 980 S. Isabella Road, Mt. Pleasant, MI 48858 · (989) 773-7981 or (800) 733-8829 · Fax (989) 773-3210
PREVENTIVE MAINTENANCE
Gasket Maintenance
Gaskets require regular cleaning to prevent mold and
mildew build up and also to keep the elasticity of the
gasket. Gasket cleaning can be done with the use of
warm soapy water. Avoid full strength cleaning products
on gaskets as this can cause them to become brittle
and prevent proper seals. Also, never use sharp tools
or knives to scrape or clean the gasket, which could
possibly tear the gasket and rip the bellows.
Gaskets can easily be replaced and do not require the
use of tools or authorized service persons. They can be
pulled out of the groove in the door and new gaskets
can be pressed back into place.
Drawer Maintenance
Drawer Assembly Cleaning
The drawer assembly is designed to be cleaned
easily. Both drawer and tracks are removable without
tools. The drawer tracks are dishwasher safe or can
be cleaned in a sink with detergents and a soft bristle
brush. Drawers and tracks should be cleaned on a
weekly basis.
Remove Drawers
Pull the drawer box out until it stops. Lift up on the
drawer front and pull the drawer box completely out.
Using a soft bristle brush, clean the track on the bottom
of the drawer box. When nished, it should be wiped
clean of all food and debris.
Tracks
The drawer box assembly must be removed. Pull the
drawer tracks out until they hit a stop. Locate blue
safety clips towards the back of each drawer track.
Blue safety clips have a tab on the top. Push the tab
back until it clicks. Lift up and pull the drawer tracks all
the way out of the
drawer cage. The
drawer tracks are
dishwasher safe or
can be cleaned in a
sink with detergents
and a soft bristle
brush. Drawers and
tracks should be cleaned on a weekly basis. Using a
soft bristle brush, wash the track making sure each
roller is thoroughly cleaned. The drawer cage should
be cleaned with a soft bristle brush, removing any
food and debris gathered on the bottom ledge. Once
it’s cleaned thoroughly with a soft bristle brush, wipe
remaining debris clean with a soft towel.
Reassembly
Push the drawer tracks into the drawer cage. The blue
safety clip must remain pushed towards the back.
Lift up and slide the drawer track all the way into the
drawer cage. The blue safety clip will lock in place
automatically. Once all tracks are replaced, insert the
drawer box. Rest the drawer box bottom track on the
front track roller. Then push the drawer back in place
SLOWLY. When the drawer box is about half way in
you will hit a STOP. You must lift the front of the drawer
up approximately ½” (1.3cm) to continue inward. Clean
tracks as often as possible. The cleaner the tracks are
the better they will operate.
tab on top of
blue safety clip