Filter
Top Products
7
Versa Drawer™ Refrigeration Units
Deleld · 980 S. Isabella Road, Mt. Pleasant, MI 48858 · (989) 773-7981 or (800) 733-8829 · Fax (989) 773-3210
Buttons are located next to the drawer display on
the Control Panel. The drawer select buttons select
the drawer to be congured.
These arrows are used to change a drawer to
operate in a desired mode (refrigerate, freezer,
thaw or chill).
Used to back up to the previous step.
The i button is used to initiate the manual
defrost mode.
OPERATION
OPERATING CONTROLS
All operating functions are accessible on the Versa
Drawer control panel. Operators can select the drawer
modes or activate the manual defrost. Access to
all diagnostic functions require a qualied service
technician.
Setting the drawer mode
Select the drawer mode as follows:
1. Press the button next to the drawer display to be
changed.
NOTE: Current drawer mode text size will decrease.
2. Press the UP or DOWN arrow to select between
refrigerate, freeze, chill or thaw untill desired mode
is reached.
3. Press the drawer display button again to lock the
desired mode setting.
NOTE: Text size will return to original size.
Activating Manual Defrost
NOTE: The following two steps must be performed
within 1 second.
1. Press the desired drawer display button.
2. Immediately press the button.
2-Drawer Interface Control
4-Drawer Interface Control
MAINTENANCE
2
1
4
Setting the Clock:
1. Press the [!] button until “Program Menu” appears.
2. Press the button until brackets are around “Time
& Date”, then press .
3. Press button to get to parameter to be
adjusted.
NOTE: The [^] under the text show parameter to be
adjusted.
4. Press the buttons to adjust parameter.
5. Once correct time and date are set press the
button twice to return to the main display screen.
(If no action is taken for 30 seconds control
automatically returns to main display screen).
Fahrenheit to Celsius
1. Press the [!] button until "Service Menu" appears.
2. Press the button until brackets are around
"Conguration", then press [!] .
3. Press arrow to "System" and press [!] .
4. In this menu will be "Metric", change to Yes.
5. Press arrow until back to main menu.
3